• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Harland sharp rockers



I did it...didn't really make a difference. They're heavier than stock rockers...and cost money...so save money and run stock crap, or spend money and get the same results as stock...your choice.
 
Agreed, when I was going to cam a vendor (Intense) talked me out of what I'll call extras that weren't needed and wouldn't add anything.
 
BLUESMOKEGTP said:
Understood. What if i could get them for $80. Would that make the sting less painful or i could just stay with stock rockers
Click to expand...

As I stated earlier, they're really not needed. When I did my build, I wanted very precise numbers. There has been a rumor running around that stock rockers do not always maintain the precise 1.6 advertised ratio, so in light of that, I opted for Harland Sharp 1.6 rockers. There have been too many builds done without aftermarket rockers to justify the necessity for anything aftermarket. Save the money and put it to use elsewhere...like the timing chain area.
 




You talking about those ones in the for sales section? I actually was the first guy to talk to the seller, but I backed out after talking to Bill about it because I was considering using them with the s1x setup I'm going to do.
 
Ya in the for sale section looks like im backing out also and spend the money elsewhere. A fuel pump and rewire kit seems like a good bet
 


You must log in or register to reply here.
Back
Top