• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Gen V M90 rear needle bearings

R

rickisrad

New member
I am getting ready to rebuild my Gen V and was reading that the procedure is different than the IV. I can’t find the Gen V procedure in any of my searches. Do any of you know where I could find that info as well as the rotor pack????

I bought a complete rebuild kit from ED. :)

Thanks all
 


I needed to buy a blind bearing kit from amazon in order to get the needle bearings out. You need to break the plastic bearing case and remove all the loose bearings. Then use the blind hole puller with the press option instead of slide hammer. Heat lightly while pressing/pulling out.
 
You must log in or register to reply here.
Back
Top