• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Eaton Gen V supercharger rebuild question

R

rickisrad

New member
Hi all,
I rebuilt my Gen V supercharger snout and rotor pack. My question is how freely should the bearings move on the snout after rebuild? They seem a little tight to me. The rotor pack seemed to come out ok and timed right. The case bearing race still need to be removed. I took the casing out of the needle bearing so I just need to pull them out.

I’m going to sell the unit cheap because of this but was wondering about the snout.
 


Btw the snout is all good. I had to press a bit more. Moves nice and smooth and has a Viton seal and comes with ZZP coupler.
 
You must log in or register to reply here.
Back
Top