• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

CV boot separation during LCA change

Garandpa

Garandpa

New member
While changing the lower control arm on the passenger side, I managed to pull the axle out from the trans, separating the boot. Was able to stuff it back in and re-seat the boot, but could not manage to get the boot clamp re-installed. I need to take it to my mechanic for the alignment and have him reinstall the clamp, is it safe to drive it ten or so miles with no clamp on the boot?
 


I would use a couple of good zip ties at the least and get them as tight as possible. The only real issue is if it leaks the grease all over.
 
So in searching for a replacement clamp, I realized that I have used similar clamps in the past from Oetiker. They get their final tension from crimping a small area on the clamp. I was able to un-deform the crimp area, install it back on the boot, them re-crimp it to tighten. Problem solved!
 
You must log in or register to reply here.
Back
Top