• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Custom Intake and PCM Mount (pictures)



Lol....no sh**! So do you put in a vice etc..... I meant in the question was how to hold in place while drilling the hole.....lol so she don't get away from you...lmao
 


Hey, if you're worried about it just make a small dimple where you want to drill either with a hammer and punch or a small pointy phillips. Just use a small bit at first that grabs onto the dimple you made to avoid having the bit walk. Then go ahead and use a bigger bit to finish her off.
 
Last edited:
Oh and another tip. Get one of them wide rolls of masking tape and layer up the area you want to drill fairly thick. The bit will sink right into that and go right where you want. Usually works pretty good.
 
You must log in or register to reply here.
Back
Top