Mikey2769
New member
Hey folks a newbie here, so I thought I'd ask for some help for once.
I think my crankshaft pulley is misaligned because it appears to be sticking out about three threads other than the rest of the pulleys. Plus every serpentine belt I put in place gets shredded, and made very thin, or about half its width. Also, when the serpentine belt is placed in about half of the belt hangs off the crankshaft pulley.
In the picture I've highlighted the crankshaft pulley, and you notice its sticking out, but having troubles posting it so here's a link to it
http://my.picresize.com/FOOSJT46MX
Anyways, I've never seen this before.
I've never done a crankshaft before but there's a bolt in the middle of the pulley. So do I just tighten it some more so it goes in further?:th_question1::th_scratchhead: Yup, I'm lost. Any tips advice, or a "how to" post on this?
I think my crankshaft pulley is misaligned because it appears to be sticking out about three threads other than the rest of the pulleys. Plus every serpentine belt I put in place gets shredded, and made very thin, or about half its width. Also, when the serpentine belt is placed in about half of the belt hangs off the crankshaft pulley.
In the picture I've highlighted the crankshaft pulley, and you notice its sticking out, but having troubles posting it so here's a link to it
http://my.picresize.com/FOOSJT46MX
Anyways, I've never seen this before.
I've never done a crankshaft before but there's a bolt in the middle of the pulley. So do I just tighten it some more so it goes in further?:th_question1::th_scratchhead: Yup, I'm lost. Any tips advice, or a "how to" post on this?
Last edited:
