• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Aftermarket deck with GMOS 100, NO SWC

mckillin

mckillin

New member
Hey guys,

I have a 2004 Grand Prix GTP w/monsoon & swc... Was sold the GMOS-100...
Head unit - Kenwood DDX319

I have it all wired up, amp works, chimes work, onstar works but no SWC..

I've tried the auto/manual instructions for setup and can't get it to work.. At one point I had something, but the controls were all the wrong buttons, tried again and lost it all.. Very fustrating.. Wondering if anyone else has ran into this and if they have any advice or help would be great... I really miss my SWC..

Thanks
 


2000-UP General Motors Amplified/Non-amplified/Steering wheel control interface

  • Covers Class 2/LAN 29/Lan 11 vehicles.
  • Provides accessory (12 volt 10 amp).
  • Retains R.A.P. (Retained Accessory Power.
  • Used in amplified or non-amplified systems.
  • Retains all warning chimes.
  • Provides NAV outputs (Parking Brake/Reverse/Mute/V.S.S.).
  • Built in ASWC (steering wheel control interface).
  • Retains OnStar/OE Bluetooth.
  • Adjustable volume for chimes and OnStar.
  • High level or RCA level input.
  • USB updatable.
  • Retains balance and fade.
  • Retains factory back up camera.
  • Retains RSE (rear seat entertainment).
  • Retains OE satellite (pending it is not built into the radio).
 
I wanted to keep door chimes, amp and SWC and I was sold this, obviously oversold but I alreaady figured that out... I just want to get this thing working 100%
 
Here's what you may need to do, On pin A6( should be a purple wire) of the factory wiring harness ( the larger plug) you need to apply 12v signal, tap into the red wire of the aftermarket radio wire, so that there is power going to the steering wheel controls, then the GMOS-100 will be able to read the switches.
 
hey simbah i just tried that and still unsuccessful... having a hard time getting the blinkin LED to even work... key on, wait 20 seconds, hold volume down for 30 second and blinkin LED came a few times now its not lol very fustrating indeed..
 


Hmmm... ya I have invested about $250 into this gmos and just wish it would all work but I am reading numerous problems with the SWC especially my Gmos100-kenwood :S

Would i be able to run that adapter for SWC and the gmos for the rest without issues, seems like a long shot but haha
 
You must log in or register to reply here.
Back
Top