• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

4T65E-HD Input shaft seal removal



the large lip seal in the bellhousing behind the convertor? take a long screwdriver and a hammer and pound on the edge of it to fold it in, be careful not to damage the case
 
The only other seal on the input shaft itself is an o-ring. Easy with a pick. Pretty sure you are talking about the seal Anthony describes.
 
Yup, Looks like my terminology was bad. I was talking about the torque converter seal (what anthony was talking about) I decided to get a street strip rebuild from Dave at TEP. Dave also suggested the same removal method, but I'm going to let him deal with it :)
 
You must log in or register to reply here.
Back
Top