• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

2004 GTP Comp G .... Need new vacuum tee that attaches to LIM under SC Snoot

P

p coico

New member
Anyone know where I can get one of these ? Mine is cracked and seems to be causing a vacuum leak.
I believe it is the root cause of a P0068 / P0101 code condition I had recently.
Seems that the MAP sensor was not getting the vacuum level it expected.
Thanks....
 


go to advanced auto, they got small white T's, 2 in a pack for 2 bucks. then buy 6 inches of vac line, cut it into 2 inch parts, then push one on the nipple on the lim, then push the two hard lines into the other two vac line parts, then put that t in place. all fixed up for under 5 bucks.
 


yea id replace it all just dealt with replacing all my windshield washer hose while i was just trying to pacth it up i would patch it up and it would break somewhere else a week later happened a third time and drove angrily to home depot to get some tubing after i found what they needed i drove calmly home haha
 
Thanks to all.
I see that new hardline assembly is about $30 with shipping and it will take a week to get to me here on the West Coast....
I will try ScottyDoggs lower cost solution.... I can do that tomorrow ....
ScottyDoggs.... do you remember what diameter vacuum hose that is ?
And again, great joda avatar !
 
zzp sells a better assembly for $20 or you can even make your own out of the stuff they use if you have the time and save 5 to 10 bucks
 
You must log in or register to reply here.
Back
Top