2004 Grand Prix Tranny Swap Issue

[Charles20212]

hello guys i just replaced my grand prix transmission and after replacing it i have a no crank no start issue, would u guys have wiring info on how the starter is suppose to be wired and also the negative side of the battery i couldn't figure out exactly where to place it at

 

[02NavyBlue]

Ground goes right at the front bell housing bolt/stud. Slide the ring terminal over the stud, and put the nut on.

Starter..two purple and big red wire goes on big nut, small single wire goes on the small solenoid terminal

 

[Charles20212]

my wires by the starter are 2 red ones and a black smaller one, I have the two red ones fused on the stud and the black on the smaller stud also I currently have one on tranny studs and one grounded by the fender is my hook up correct for the negative side of the battery?

 

[Scottydoggs]

neg bat cable goes to the trans bell housing bolt with another wire.

 

[BillBoost37]

All set or need a diagram?

(Kinda surprised Scotty didn't post the pics from Helpful pics)

 

[Charles20212]

diagram please that would be helpful

 

[BillBoost37]

Here ya go