• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by WhiteGT

  1. WhiteGT

    Caliper pin question.

    Hey folks! While changing my rear brakes, I noticed that one of the slider pins has a rubber ring on it. Stupidly I did not notice it when pulling them out for cleaning and am not sure if the one with rubber goes in the top caliper hole or the bottom? Also, is there anything like this on the...
  2. WhiteGT

    Powerstop drilled and slotted rotors, any good?

    Hello I am replacing the brakes on my 02 Gt and came across this kit More Information for POWER STOP K2554 Wondering if anyone has used these before and if they are any good. My car is just a daily driver, but I like the look of these and the fact that the rotors are plated and wont rust is...
  3. WhiteGT

    Anyone have the LG Rumour phone?

    Hi everyone! Hope you all had a good Christmas. My GF and I were out boxing day and picked up the LG Rumour cell phones since they were a good deal. I have found alot of bad reviews online. We havew not activated the phones yet so they could still be returned. Wondering if anyone here owns one...
  4. WhiteGT

    Coil spring boosters

    Hey everyone I just put a type r box in my trunk and noticed quite a drop in the rear suspension. The damn box must weigh close to 100 pounds! It makes the car look kinda dumb with the huge wheel gap only on the fronts. I was thinking on picking up some of those rubber spring boosters for the...
  5. WhiteGT

    Noise with 4 channel amp.

    Hi everyone. When my car is running I get an interference through my speakers. It does not increase with the revolutions it just stays a solid tone. I have read the links in the search function and tried things listed there with no change. I bought a new amp thinking that was the issue because...
  6. WhiteGT

    Removing epoxy glue from paint.

    Anyone have any ideas on how to get what I think is an epoxy or some type of hard glue off my doors. The badges on my Driver door are glued on with it. I tried picking at it but it is pulling off the clear in a few small spots. Not sure if there is any way to get it off without sanding and in...
  7. WhiteGT

    Damn constant repairs!!!

    Anyone else feel like the repairs are never ending on our cars? It's like luck lately to get a week in between something else to fix. Just had the control arm bushings and alignment done a few weeks ago and now I need to get the pressure solenoid in the trans changed which is going to be another...
  8. WhiteGT

    Epc solenoid help!

    Hi everyone I have been having a problem with my tranny shifting hard once it gets warmed up and by reading up on Trannyman's page I have concluded that the problem is the epc solenoid. Is this something that I could change myself without removing the trans? I have changed tcc solenoids in the...
  9. WhiteGT

    Opinions on SLP air box.

    I am looking at buying an slp airbox and was looking for some opinions on these particular setups. They don't look too much different than the stock airbox aside from not having the baffles in the box and using the cone filter instead of the stock type. Would this be worth buying or would just...
  10. WhiteGT

    Seat heater wiring?

    Hey everyone I am looking at picking up a set of heated leather seats from a member. They are out of a 98 going into a 2002. Would my car have the wiring in the vehicle so I can just plug in the seat and switch or do I have to get the harness as well? Also is there a relay that would need to be...
  11. WhiteGT

    Msd coils make much difference over stock?

    Just looking for some opinions here on whether or not it would be worth it to upgrade. Thanks!
  12. WhiteGT

    Gears jumping around?

    For the second time in the past week I have been driving and had the tranny feel like it either slipped out of gear or couldn't decide what gear to be in. I believe it would be in overdrive when this happened, but it happened too quickly to be sure. I have checked the fluid and it looks and...
  13. WhiteGT

    Finding +and- on a cap

    Hi everyone. I have an old 1 farrad accucap that I was considering installing when I get new subs. Only problem is that there is no indication on the cap which set of terminals is +and-. I have not used it in a few years and can't remember which is which. Is there a way to check this with a...
  14. WhiteGT

    Blower motor speeds 1-3 quit working.

    Hi everyone. My blower motor speeds 1-3 stopped working on me tonight. I was reading a few threads about this and see that there are a couple things that that could cause the problem. I was figuring it was the resistor, but see some others said the ignition switch caused the issue. Is there I...
  15. WhiteGT

    High idle?

    Hi guys I find my car (3800 na) will idle high most of the time. When you first start it cold it stays up around 1500rpm for a few mins, then goes down under 1000. Once warmed up and in drive it's usually in the 800rpm range but when put in park it will usually jump to just under 1000rpm. I am...
See more
Back
Top