• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by TuKoolGTP

  1. TuKoolGTP

    New 2007 GP - Preventative Maintenance?

    So the tranny my 99 GTP which I have had for 14 years just took a dump. Decided not to repair it. Picked up a new 2007 GP (137,000 Km) for just a little more than what it would have cost to repair the tranny. The series III has the metal LIM gaskets so I think I am OK there. Any other...
  2. TuKoolGTP

    Power Steering Fluid in Master Cylinder

    I can't believe I did a bonehead move and topped up the master cylinder with power steering fluid. Didn't realize it for 2 weeks. Once i realized what I did, I flushed the system with new Brake Fluid. But I assume it was too little too late. So I think I am in for a brake system rebuild and...
  3. TuKoolGTP

    Help Confirm Diagnosis?

    My car has had a hard start problem. Doesn't want to start with just a key turn. Takes a little press of the gas peddle to start. Runs fine once started. I swapped the Fuel Pressure Regulator with my other car. After swap the car starts fine. The car also had a p102 MAF code. I pulled the MAF...
  4. TuKoolGTP

    Pace Car rear shot........

  5. TuKoolGTP

    A Quick Pic of the twins

  6. TuKoolGTP

    Alternator Rewire Fuse?

    Anyone with the Alternator Rewire running some kind of an inline fuse?
  7. TuKoolGTP

    Need Help with short!!!???

    I replaced the oil pan this week end. Committed a cardinal sin and did not disconnect the negative terminal of the battery before lifting the engine. Part way into the lift something shorted. Seemed to be in the area under the throttle body above the transmission. Car started fine and everything...
  8. TuKoolGTP

    Need High Beam, Low Beam, Fog wiring help...

    I have run new wire harnesses for the head lights as well as the fog lights. I am using the factory wiring to turn on the relays for the new wiring. I am also running the Spyder projectors. I added diodes to turn on the Low Beams and Fogs when the High Beams are on, as before they would shut...
See more
Back
Top