• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by torqueaddict

  1. T

    Y pipe to rear exhaust leak between engine and firewall on 2000 GTP

    Hi - Just wondering how hard this is for DIY. I have a 2000 GTP and I ran over something and caused a leak - looks like there is a small flex line where the Y pipe connects to the rear exhaust between the engine and firewall. It seems hard to get to but I was wondering if there's some tricks...
  2. T

    2000 GTP - Part # for throttle body to EVAP hoses (flex)?

    I'm looking for a part # (Dorman, Delco, etc...) I have a 2000 GTP and I hope I just discovered the source of my P0440 code. There's a hose which comes off of the throttle body, it starts off pretty fat then reduces, and curves, then plugs into a hard plastic line which extends over the...
  3. T

    2000 GTP HVAC blower module keeps burning out ??!

    Hopefully someone knows about this problem I have a 2000 GTP with climate control. My blower motor went from intermittent to not working at all. I bench tested the motor and it was fine so I replaced the module. Module looked almost melted where the plug goes in and plug also looked a little...
  4. T

    questions: MP3 input on Bose 2000 GTP single disk (PAC/PIE?)

    Hi - I have a 2000 GTP with a single disk Bose system. I was thinking of these adapters for mp3 inputs since I figure replacing this stereo would mean I'd lose the factory amp, need additional equipment for the steering wheel controls, and the new stereo wouldn't look as good (imho) Anyway...
  5. T

    2000 GTP fuel pump relay problems

    Hi - I have a 2000 Grand Prix GTP, and I had the notorious stalling issue. I did the pin bend as described on the forums and it ran great and got the car home. I went to autozone and bought a replacement relay : Part 19271. I plugged in the autozone relay and it wouldn't run! Out of...
  6. T

    after tie rod repair- front creaking noise only while moving

    Hi - I have a 2000 GTP, 135k. I replaced the inner and outer tie rods, and had the car aligned. After this, I started hearing this creaking noise which increased in frequency the faster I go. I never heard this noise before. When stopped, there's never a noise even if I try to bounce the front...
  7. T

    ABS unit repair? cheapabs.com?

    Found this site that seems reasonable -www.cheapabs.com any experiences?
  8. T

    inner tie rod replacement - using feeler gauge to check "stakes"??

    I am about to do my inner and outer tie rods and I see the following step: "Insert a 0.25 mm gauge (1) between the rack (2) and the inner tie rod housing (3) in order to check both stakes. The feeler gauge (1) must not pass between the rack and the housing stake. " Can someone tell me what...
  9. T

    anyone familiar with the various abs module 97 - 03?

    I think I need an ABS module, so I went to the u-pull it. I found Grand Prix of my generation 97 - 03 and pulled the pump and module - looked identical. Brought it home and found the unit I pulled was actually about 1/2 " shorter than mine. So I am wondering: Anyone know how many variations...
  10. T

    2k GTP ABS/TC lights and no codes??

    I've been having the lights come on intermittently for weeks now. It seems to only come on when I do a lot of stop and go. When I first start up it's off sometimes. I ohmed out the sensors and all looks normal - resistance changes when I spin the wheels. I tool it to AAMCO (nobody else would...
  11. T

    any recomendations on a sub $300 ABS code reader for a 2k GTP?

    I have a 2000 GTP and the code readers I've found only work for 2004+ Grand Prix's. Any recommendations on a reader? Pep boys wants over $100 to read the code! thanks in advance
See more
Back
Top