• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by torq455

  1. torq455

    Vehicle Not Responding.

    I just got done rebuilding the entire top end tonight. It started up just fine, but, as I expected, the check engine light was on. So, I went to connect my scan tool to pull the codes and it would not connect. I've never had this happen before, and yes, the ignition was on. What would cause...
  2. torq455

    SD Headers Plugged. What to do?

    I had some surging issues under boost. Cruising and light throttle are fine. I put a scan tool on the car to see if I could find anything. I discovered that the more throttle I gave it, the more fuel was being subtracted, up to -22%. It was time for the LIM gaskets so I took all of that...
  3. torq455

    A little help?

    I can't seem to find the search function anywhere. Can someone tell me where it's supposed to be? I may need contact a moderator? Thanks.
  4. torq455

    Oil pressure kits

    I've been searching and can't find any details about the spacer used. Anyone know if it's hardened, or how thick it is?
  5. torq455

    Got Dyno Tuned Finally

    I thought you all might be interested in some numbers now that I got the GTP dyno tuned. My mods are in my sig. I did find out my Intense Racing tune was bad-both with timing and fueling. My final pull with things thoroughly heat soaked was, WHP 213 @ 5000 rpm and WTQ 245 @ 4200 rpm...
  6. torq455

    Shift Points

    According to my tach, my shift points are at 5500rpm. Stock. Should I go any higher once I get headers on? If so, how much higher? Or, is there no point revving past 5500rpm?
  7. torq455

    Plog or downpipe first?

    I have money for one or the other, so I'm wondering what thoughts were out there. Should I spend the money on a Plog first or a 3"bolt in downpipe? Which would benefit the car more right away. Thanks!
  8. torq455

    Billet accumulator pistons?

    I'm trying to find out if and who makes accumulator pistons for the 4T65E. Anyone know anything about this? I can't find anything, but I've heard about them.
  9. torq455

    Should I and what to replace??

    Hello all! You probably can see that I'm new here, so, ya know...hi and stuff. :th_laugh-lol2: Seriously though...I have been observing for a little while, and I have to say that this is a great forum with nice, helpful, non-ego people. How nice! I need your advice. I'll start off with a...
See more
Back
Top