• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by tonglebeak

  1. T

    SSIC setup and 3.0 MPS pulley

    Hi, I have a SSIC setup for sale. I bought it a year ago after the mod bug bit me, but then I had to get the tranny rebuilt, so I never put it on. It was used by the previous owner. Here are a couple of hi-res pictures: http://img846.imageshack.us/img846/4519/img20121101152816.jpg...
  2. T

    Broke a part that feeds the brake booster

    What's it called? It has a few vacuum ports on it. One is capped, one goes to the brake booster (which completely snapped when i touched it).
  3. T

    SS intercooler install + LIM gaskets question

    1) When installing an ss intercooler, are longer supercharger bolts required? If so, what size do I get and how many? 2) Did the l67s on the 2004 impy ss come with the plastic LIM gaskets from the factory? Thanks!
  4. T

    quick disconnect cooler line on bottom of the rad

    Anybody have any novel ideas to get the connector on that one? I can't squeeze my hand down there at all.
  5. T

    converting tranny cooler lines from 1st design to 2nd design

    Is this possible? I've read that all you have to do is change the fittings on the rad and tranny cooler inlets/outlets, and then you could use the 2nd design lines. However, that was from one source and no one verified it. 04 impy with the 4t65e-hd. Built in january of 04 so it has the 1st...
  6. T

    excessive wheel/road noise after tranny rebuild

    I had my tranny rebuilt (only 7 years old, thanks a lot asshole owner who owned it the previous 6 years) back at the end of december. Now that it's warm outside, I'd like to know where to go with this: THere is a lot of noise at around 30mph. Sounds like a buttload of low-frequency resonance...
  7. T

    tranny cooler psi?

    I had a leaking cooler line (leaking at the crimps). I had purchased new hoses but returned them as a couple of the bends seemed to be flattened, and of course I was worried this would cause problems. I ended up splicing 3/8 power steering hose and double EFI clamping both ends. I ran it at idle...
  8. T

    04 impala indy problems.

    I have a thread on naioa about this, but I'm just looking for more opinions as things are running slow over there. There's a noticeable grinding/growling noise, dependant upon wheel speed and under load. With the throttle up, the grinding/growling noise is mostly replaced by a noise that...
See more
Back
Top