• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by theone2043

  1. theone2043

    Trans Issue

    I just threw a P0758. It just happened sunday for the first time. It happened after I was idle for a while and went I went to pull off it felt like a surge and that I lost power. I had to rev it to about 2.5/3k before it would slowly go. It seemed to shift fine after I was off the line. Drove it...
  2. theone2043

    Maf fail

    I think I have been plagued with the P0102 code since I did my top swap last fall. For whatever reason, I have over looked it till now. I have it narrowed down to the fuse is blown. I replaced it three times and each one blew. Can it be the wiring for the 97 gt is different then for the gtp...
  3. theone2043

    Trans dipstick question

    When the tran dip stick is removed about how much fluid is lost? Is it safe to run with that amount out for a short time till I can get more?
  4. theone2043

    pt question...

    i am able to read the new pcm just fine. i tried to do a partial write of the my old pcm file that i read last night... it came up with an message saying it was unknown that i would need to do a full or auto write. so then i tried to do a full write it failed at step 19 of 25 when it was waiting...
  5. theone2043

    fuel pump voltage

    how many volts do you need for the fuel pump ? im only getting 2.82 on the stock harness and nothing on the hotwire unless the stock is connected to it...
  6. theone2043

    no fuel

    replaced the stock pump, installed a hotwire kit, replaced the relay checked the fuse still nothing how do you prime the system what else can i check? oh i have a 97 gt recently top swapped
  7. theone2043

    car will not turn over *update*

    Car sounds like it wants to turn over but cant. Checked everything and found the reason is no spark. Replaced the pcm still no spark. tried a stock coil pack, still no spark were can i look next to find out why i am not getting spark?
  8. theone2043

    Probably a stupid post, i just want some knowledgable options.

    Why is stroking to a 4.2 overlooked so much? I know the price is high and could be used other places. But how much of a gain will there be if you do this and then add a blower and drop to a 3 something or lower pulley.
See more
Back
Top