• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by Slueth66

  1. Slueth66

    Installed hids and got some questions

    So i just got my new hid bulbs installed, and i was wondering if it was normal to see some flickering in the light. When shinning on the garage door, each side has a spot in the light output that flickers and is not constant like the rest of the light.. it also seems to be dimmer in these spots.
  2. Slueth66

    Inline fuse / fused power distribution block

    So im installing a massive 0 gauge dual amp kit in my gp, and it has a inline fuse and a fused distribution block. Do i need to use both of them? The inline fuse is 250 amp, while the distribution block has 2, 100 amp fuses. Im running a 1200 watt amp, and a 1000 watt class d amp and not sure if...
  3. Slueth66

    reomve or keep 4" speakers in rear deck?

    Im planning on running a 4 channel amp to the rear and front, but not sure if i should just leave the 4 inch speakers installed and not powered, or remove them? I have read something about it creating a bandpass like enclosure, but am still not sure if that would be a good thing or bad thing.
  4. Slueth66

    Signal to noise ratio?

    can someone break down what a higher signal to noise ratio does on a amplifier? I get that its the ratio of the signal to background noise, but what does this affect when talking about subs? is a higher signal to noise ratio just clearer? or is it louder? just need some help. thanks
  5. Slueth66

    H3C Hids

    I was wondering if anyone has found a seller on ebay that sells H3C hid bulbs. All i can find is H3, which is far to large for most aftermarket fog lights. Any help is greatly appreciated. Thanks
  6. Slueth66

    Hids in Projectors?

    So i noticed that my H1 bulbs had a very tight fit in my projectors. Anyone else notice this??? Anyway around this problem? Thanks
  7. Slueth66

    55 or 35 Watt hids?

    Im just curious to see what type of hids most of you guys are running in your gp'S cause im debating over 35 or 55 watt hids with spyder projectors. Tell me what ya think.
  8. Slueth66

    aftermarket head unit radio reception problem

    I installed an alpine 9887 and now my radio sounds like complete garbage. What causes this? did i forget to hook something up? Im not a fan for listening to static.
  9. Slueth66

    amp settings

    I got a kenwood 1000 watt amp running at 2 ohms which is hooked up to my alpine deck with 4 volt preamp outputs. if a deck has high preamp outputs does this mean i need less gain to equal the same power from the amp thats hooked up to a 2 volt out put?
  10. Slueth66

    firewall holes?

    can anyone tell me where there is a good hole/gromet in the the firewall where i can run my new fog light wiring through? i need some help.
  11. Slueth66

    hid lights off ebay

    So i want to buy some hids off ebay. Is there any brand i should especially look for or are they all pretty much the same?
  12. Slueth66

    relay harness questions

    I installed a 9007 relay harness today and now when i have my fogs on and switch to brights it runs both the low and high beam filament. What is the reason for this i know its not good to run both at the same time so how do i fix this?
  13. Slueth66

    9007 bulbs

    whats the best 9007 bulb without going hid?
  14. Slueth66

    setting up new system

    So i want to power all 6 speakers that i replaced in my gp that were powered by the bose system? should i buy 2 amps to run all 6 speakers or run 4 speakers off the headunit and 2 from an amp? if i run all 6 speakers off 2 amps all my pre amp outputs are taken up and i was wondering how i would...
  15. Slueth66

    bypassing Bose amp

    Is there any way to bypass the bose amp in a 2001 grand prix? Or do i have to run new speaker cables to all 6 of the speakers? Im installing a new head unit and want to run the speakers off the head unit
Back
Top