• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by skills4lou

  1. S

    2000 GTP in Missoula, MT

    I've decided to sell my GTP. I'm asking $3800 on CL, but willing to entertain offers. New CV axles, lower control arms, rear brakes, windshield. Intermittent P0401, EGR valve checked out, no carbon in the intake. Possible MAP sensor? Body is very good, interior is excellent. Sent from my Moto...
  2. S

    Wiring diagram, 2000 GTP

    Do any of you have a wiring diagram for said car? I'm going to try to diagnose my EGR not getting power. I already know the valve works, it's just not getting power from the computer. The control signal is there, but no power to the motor. I bought a wire tracer to try to track down a break in...
  3. S

    Vibration under acceleration.

    2000 GTP. Lately under acceleration (freeway on ramp) I've noticed a vibration. It's worse when I go through a dip and the ground is rising again. Also, the vibration goes away completely when I lift my foot off the go pedal. I'm thinking drive axles? There is no low speed grinding when turning...
  4. S

    Surge on Acceleration

    Hi all, Lately the GT has been surging under what I would call light to moderate throttle. It only does it between about 1950-2400 rpm. If I step on it enough to rev up above 2500 rpm it completely goes away. When its surging the rpms go up and down between about 2000-2300. Any ideas what might...
  5. S

    Bought another, time for gaskets.

    Hi all, I just bought another Grand Prix, this one a 2000 GT. Originally it was to be a parts car ($250) for the 2000 GTP. The PO said his daughter was driving it and it just quit. Rather than putting any money into it they decided to just sell it and buy a newer car. SO, before yanking any...
  6. S

    Bad stumble, but only on hard accelleration

    Hi all, This morning I decided to open her up, and discovered a pretty bad stumble. Recently replaced MAF, air filter, plugs, wires and most of the vacuum harness, to get rid of a miss under light acceleration. Thought I had that sorted, so I decided to play. I don't have my good scanner with...
See more
Back
Top