• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by Scott Kane

  1. S

    AC Compressor Leaking

    Just installed this used AC compressor from Morad the other day. Replaced orifice tube, accumulator, and all o-rings I could. Flushed system and set on vacuum for at least an hour. Left over night after disconnecting vacuum and held ~29 in Hg. Charged with 36oz (2.25lb) r134a per TSB...
  2. S

    New Front Crank Oil Seal Leaking - Grooved Balancer?

    After solving my oil pressure issue (bad sending unit), I've now developed another oil leak. I recently did a timing chain job, replacing all gaskets in the Fel-pro kit including new National front main seal. I ran her hard the other day looking for problems and well, I found one. The front seal...
  3. S

    Oil Pressure Light On After Timing Chain Replacement

    Just recently did the following: -Timing Set w/ new gaskets -Water Pump w/ new gasket -Oil Change 5qts 10w30 -Belts -Hoses -Tensioners -Coolant Elbow -SC Coupler I packed the oil pump gears with petroleum jelly prior to reassembling. I was sure to install the oil pressure relief valve and...
  4. S

    HELP! Identify the missing piece.

    Is this just a missing freeze plug or what? It's on the driver's side block below thermostat housing.
  5. S

    Corrosion on new timing sets? Plus advice on coolant elbows, LIM, AC, waterpump, etc

    New here, but have been reading quite a bit. I'm getting ready to replace my timing set/damper/gaskets, coolant elbows, tensioner, belts, coolant level sensor (mine's bad), water pump/gasket, transmission filter/gasket, ac compressor, ac accumulator, orifice, PCV, SC coupler (green-I've got the...
See more
Back
Top