• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by revin24

  1. revin24

    Wiring harness problem need info please help

    I pulled the motor out of my car 2 yes ago and we ripped off some sensor wires I went to the junkyard to get replacement plugs but the colors are different this is the section of harness that goes behind the alternator goes down to the knock sensor, the rack, oil press, vehicle speed sensor...
  2. revin24

    Series 2 entire setup with hand ported heads

    I'm selling my entire series 2 set up including harmonic balancer all pulleys and Brackets ported heads2 new head gasket new head bolt set reusable rocker arm bolts metal intake gaskets it all needs to go so just gimme some offers thou I would like to sell it all together if possible for some...
  3. revin24

    Stock motor, e85 how small of a pulley can be ran assuming custom tune

    All stock motor only full exhaust and k&n fipk on E85 how small of a pulley can be run obviously it needs to b tuned but let's just run it to the ragged edge what about a 3.0 or a 2.8 hmmmmmm
  4. revin24

    Need some advice on how I should Finnish my build

    I want to stick to the SC but I'm not100% I have hand ported my heads the block needed to be bored . 02 over I personally love the sound of superchargers so I need a little help figuring this out I'm going to run 140lb Springs because eventually I want it to Rev past 7000 I want to run at...
  5. revin24

    To rebuild or buy need trans to support 500hp +

    Need to know is it cheaper to buy a zzp trans or rebuild my own I need it to withstand an 8000rpm goal hopefully the supercharger can still make boost at that rpm on a 2.8 pulley and not stall out and I'm aiming for 500whp I hope someone can help me with this cuz I'm trying to get the engine put...
  6. revin24

    Series 2 rods how much power can they handle

    Im rebuilding my series 2 and i want to run 7000 rpm and a nic cam on e85 i need to know what they can handle before the machine shop starts to balance the rotaing assy Sent from my LG-MS770 using Tapatalk
  7. revin24

    Who's running a VS cam because im thinking about it

    Im thinking about running a VS cam and i would like to know peoples experience with it what fuels your running how bad is the mpgs and dose it work for a daily driver Sent from my LG-MS770 using Tapatalk
  8. revin24

    Car Pictures

    Sent from my LG-MS770 using Tapatalk
See more
Back
Top