• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by Professor X

  1. P

    Crankshaft position sensor 06 GP 3.8 SC

    Do I need to remove the harmonic balancer to get to the crankshaft position sensor?
  2. P

    Filling coolant

    I drained and flushed the radiator. When I was trying to fill the radiator I could only get a little more than a gallon in. I was running the car, ac on and i has the rad cap off and the thermostat bleeder screw open. But I never got more than a couple of drops out of the bleeder screw. Over the...
  3. P

    Won’t start after sitting for a year (2006)

    I got some tips in the chat section on my desktop but can’t find that on my phone. Anyway, I replaced the battery, had the starter rebuilt and retested after the fact. Voltmeter says I’m getting like 1.8-2.4 to the ignition (?) wire at the starter (the purple one). Thinking my problem might be...
  4. P

    Should drive axles be replaced in pairs???

    I don't have much more than that, just replaced the passenger side (drove with a torn CV boot for a looong time). Also replaced the motor mount. Replacing the tranny mount tomorrow and wondering if I should replace the drive axle as well while I'm down there. Thank you in advance, really...
  5. P

    CV axle replacement ?

    Short version: How do I know that the replacement axle is fully seated or engaged with the transmission? Does it click? snap? or do i just go by visual inspection? Long version: I replaced the passenger side CV axle on my '06 3.8L-SC GT. I drove it across town (about 25 miles) back home and...
  6. P

    Car won't start after repair

    Good morning, new user, first post. I replaced the valve cover gaskets on my '06 3800 SC GP. After hooking everything back up the car ran rough for about a minute then shut down. It would not turn over at all. After a few minutes it will now turn over once but not start. I triple checked my...
See more
Back
Top