• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by Prd2010

  1. P

    1/8 mile race

    Went to an eighth mile track. Ran into the 8s with street tires. Apparently that's not too bad from what I've read. I can post a video link but don't have it yet. I have one video racing 90s camaro. Its bracket racing. So the camaro gets the hit. He also has a full set of Hoosiers that probably...
  2. P

    Trim relearn question

    My cars was already fueling perfectly. I just changed some non fueling parameters. Do my trims still need to relearn? This was a partial write using dhp. when I last programmed it ltfts were right where I needed them from the start. I waited my hour drive time and four starts for wot run. I'm...
  3. P

    Trans swap....

    I have a 2004 comp g. Abs tcs asm is all off. I don't care if the tapshift works or not. I want to put a normal 04 05 transmission in it for abundance reasons. I understand that gearing needs changed and possibly all the trans tables which is not a problem. Also passenger cvaxle. This is...
  4. P

    Getting avt852 box working with dhp

    Ok, I bought one of these boxes to use with dhp. I started off with a windows 7 dell laptop and could not get framework 1.1 to install. My friend at work took the computer for me and said he had to put windows xp on it to get the framework to install which works for me the laptops just for this...
  5. P

    Subframe swap question

    So I have a 2004 gtp. The subframe is slightly bent from a previous owner. I also own a 2003 impala 9c1. Now I'm going to swap the impala subframe to the comp g and keep the gmpp sway bar obviously and such. My question is, which I don't see why it would matter, I can keep my pre-existing 2004...
  6. P

    Modifying rockers

    I've heard that a set of the 1.9 rockers zzp sells are the stock rockers and seat altered. I'm a cnc machinist by trade and was trying to specifically figure out how to do this myself. The only thing that makes sense to me at this point in time would be milling. 030" off the seat. I've asked...
  7. P

    Just changed lim, reduced power on display center

    Just replaced lim on my 04 comp g. I found a broken vacuum plug, not sure where it came from. I think it may be the t under the supercharger, it's old, but I can take the line that runs out of it and it still has vacuum. I'm thinking it may be losing some vacuum, but not enough to make it so the...
See more
Back
Top