• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by NinetyEightGTP

  1. N

    Solenoid part numbers

    I'm looking for A, B, PCS, and TCC. My trans has an intermittent issue where sometimes it doesn't like to go into 4th and after about a mile or so in 3rd, it'll finally go into 4th. The gears all feel fine, so I'm thinking it might be a solenoid issue despite no code. I'm gonna throw all of...
  2. N

    Very occasional hesitation before OD?

    Well, this has been an issue for a short while now and I'm interesting in selling my car and want to know how serious it is: When the car is cold it won't shift into overdrive, but I'm thinking this is by design. However, once everything is warmed up, it occasionally won't get into OD after...
  3. N

    GTP down on power

    Last week while passing someone my GTP died and I replaced the CKP and now it doesn't seem to have the stalling problem, but it feels like it's down on power and the exhaust is nowhere near as raspy as it was. I'm not excluding the possibility that the cat got clogged up somehow, but it just...
  4. N

    Shut off while driving.

    Was driving along, getting on it a little bit maybe 75% throttle, and then it just cuts out with a nice little backfire (I'm assuming from it having cut out at like 4 grand) and then that was it. Tried to go and put some gas in it thinking the gauge might be wrong, but it just turns over. Didn't...
  5. N

    boost leak/ vac leak

    I have my scangauge set to boost and on a 3.4" pulley, it's saying I peak at 7.1
  6. N

    SSAC headers & cat

    I have SSAC headers on the car, and I'm looking for a cat that will just slip in where that test pipe it comes with goes. Anybody done this, any suggestions?
  7. N

    car running unusually cool

    Took a good while for it warm up this morning, was cruising gently and took maybe 5+ minutes to reach 140, and then it hovered around 160, even though I've got a 180* thermostat. I'm thinking it might be a leaky thermostat o-ring, partially stuck thermostat, etc. Any other ideas before I tear...
  8. N

    alternator brace?

    So there's this black bar, which I'm assuming is the alternator brace. Is this thing essential or can I just leave it off? I lost the bolt/stud combo that went on the front dogbone and held it in place so I replaced that with a regular bolt and now I've got nowhere to put this sum*****.
  9. N

    S/C questions.

    1. I'm assuming the snap ring on the snout just pops in right in front of the seal? 2. What's the thread size on the little breather nut/screw
  10. N

    Cometic head gasket arrow direction?

    Looks like on these L67 head-gaskets the arrow faces the wrong way? Can anyone confirm?
  11. N

    head torque specs

    Don't have a Torque-to-angle wrench, so what's the ACTUAL ft-lb torque spec for the heads, and what steps should it be done in?
  12. N

    Cometic MLS question

    So what's the deal with those top coolant holes being so damn small.. is that normal?
  13. N

    Steering linkage broke?

    I was doing the "lower subframe cam install" and it seems that the steering linkage is broken. Wheel spins freely. What do I do now, and where would it have most likely broken?
  14. N

    Oil pan removal and gasket replacement

    So is there an easy way to do this or is it going to be the ****fest that I think it is? 'Cause looking from the bottom of the car it appears to be a real mother****er sandwich.
  15. N

    Part numbers

    I need part numbers for two different parts, and I couldn't find them looking around anywhere else: 1. rocker arm bolts (presumably a set) 2. cam thrust plate screws
See more
Back
Top