• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by Boomersooner

  1. B

    Traction control turns on when entering and leaving parking spaces

    No lights are on my dash, but my traction control engages and makes noise when going extremely slow and trying to maneuver in and out of tight parking spaces (briefly shows up on DIC). No codes, no lights, and works perfectly all other times. Any suggestions why it does this?
  2. B

    Strut caps

    I replaced my rear struts and I was wondering how to re-install the rubber cover (the round rubber domes that go over the top, that are inside the trunk). I am not really sure what they are for, and I couldn't put them under the edge before installing the strut due to the far back bolt that is...
  3. B

    Recent loss in stability

    I am trying to determine what might be wrong with my car. When driving on the highway around a curve with an uneven surface the car seems to jolt to one side when going over the uneven surface. It seems like this is most noticeable in the rear of the car. This happens a few times a week...
  4. B

    Where to wire rear view camera for power?

    I will be installing a rear view camera, and I want it to have power whenever the car is on (not just when in reverse. Any suggestions on where to wire it?
  5. B

    How to remove 2004 - up Reverse Light Housing?

    I am trying to remove the reverse light housing on a 2007 GP. I see the 4 bolts inside the trunk lid, but once I remove those I am not sure how to get the lens off? I presume it is supposed to be removed (thus the reason for the bolts), but I can't figure out to get it to budge. Thanks!
  6. B

    High beams turn on intermittently when using turn signals

    2007 GT....When my headlights are on and I use my turn signal, the high beams randomly turn on, sometimes stay on, and sometimes go off. I am not pushing or pulling in the switch (which normally turns on the high beams), I am just pushing it up or down to turn on the turn signals. Has anyone...
See more
Back
Top