• The site migration is complete! Hopefully everything transferred properly from the multiple decades old software we were using before. If you notice any issues please let me know, thanks! Also, I'm still working on things like chatbox, etc so hopefully those will be working in the next week or two.

Recent content by BlackGS

  1. BlackGS

    Wheel Bearing Bolts - Replace?

    Time to do the front driver wheel bearing - again. Last time I reused the three bolts holding the bearing from the back, but I noticed the service manual is pretty clear about using new bolts. Should I get replacements? If so, where can I find them? New bearing didn't come with them.
  2. BlackGS

    Chasing low throttle misfire - Any suggestions?

    I'm getting misfires on cylinder #2, but only when the throttle position is less than 5% (light cruising, idle, park, etc.). Any throttle over 5% and the misfires are gone. This started about 2 weeks ago right after I switched back to 93 gas from e85. I really don't think the switch back...
  3. BlackGS

    ATI Super Damper - Anyone know the torque specs?

    Just wondering what the torque is on the main bolt for the ATI Super Damper. Can't seem to find any info in the instructions, or whether it should be torqued the same as stock, which is 111 ft. lbs. + 70*.
  4. BlackGS

    Crank Pulley/Balancer Opinions

    I am building up my engine and tranny right now and considering replacing the stock balancer. There are a couple different options I'm exploring, and would appreciate any feedback on these: Option 1: Replace the stocker with a PowerBond stock-size 8-rib unit. That would cost $129. Option 2...
  5. BlackGS

    Hooked up a Fuel Pressure Sender (with pics)

    I finally got around to hooking up my VEI Fuel Pressure sending unit. I have the ZZP fuel logs, but this could also be hooked up to stock rails if you get an adapter for the front schrader valve. I wanted to hook this sender up and get the signal back to my HP Tuners scan, although it could...
  6. BlackGS

    Parts are in for fuel line replacement

    Just got all the stuff to replace the nylon/plastic portions of the fuel lines. I also picked up a fuel pressure sending unit.
  7. BlackGS

    Crossing Over

    Hi guys. Great site! I'm a long-time member on the Regal site and some of the other GP sites, and I see a lot of familiar names here that moved over, so I know this forum must be good! :D I'm setting my goals now for a complete tranny upgrade and possibly twin-charging after that, so I hope...
See more
Back
Top