Thread: What should I do with my car?

Heres the new tips, what do you think? minus the dust lol

They look kind of... beat up? Almost look like piping to be honest.

no they are stainless steel, just dusty and dirty form the drive home and the oil from my hands where I held on to them... I will get a clean pic on here eventually.... I just meant as far as the style and positioning, not the fact that they look like sh*t cause they are dirty

To me they stick a bit far out, maybe a bit low, and maybe its just the angle but, they almost look bent?

you touched them with your hands, then drove somewhere and got them hot? they are now stained because you touched them. should have cleaned them before you got them hot.

sticks out a bit far, would need to see a less above view to see if they are too low etc.

and yeah x2 to what bio said about touchin em. hope they were not polished.

this is a little better pic w/ the new lettering included...

And no I dont think they got the fingerprints burnt on them, i polished them up this afternoon and they looked ok(thank god).... And they look bent/ crooked in the pic I know, but when I look at them they look fine, and the camera angle does make them look like they stick out a bit far but its not too bad. I'm not cutting the pipe and welding it again for a half an inch I guess i'll live with it.

do yourself a favor and get some long hose clamps. use them to tuck the tips up into the bumper like the picture above. it really cleans them up when they are where they are supposed to be.

I know, I know.... I f***ed them up a little. maybe I'll get the ambition to fix them one of these days, it's not that hard once I thought about it I could just slide them back a bit. maybe I will...

yeah I might try that because I don't think they are really any further out that the ones in the picture above, they are just down a little low, but without a clamp or something, there was really no way for me to move them up due to the factory mounting setup. Ill grab some clamps and try that, thanks!!

wrap the hose clamps around the muffler hangers and tighten them up.