Thread: Did Some Work On the Prix Today....

Here's the spoiler drainage fix. Man I couldn't believe all the sh!t that was under there.... Gross.


Well... I did these a while ago but I fixed the condensation in the headlights and I restored them. But I used the wrong clear coat... Need high temp because now I have bubbles from the clear heating up too much..... Next is clear corners!




And finally sanded the tips!

10mm socket takes off the wing.

Lower number grit...then move to higher number grit to smooth it out.

Honestly, to tell you the truth I just found some sandpaper that had a not to big and not to small grit size and put it on my sander and went at it took about 2 min. And there is like 5 or 6 bolts that are on the inside of the trunk. just lift the lid and they should be there.

^what he said. i just sanded them to get rid of the black chit.

On the bottom of the trunk lid?













lol.........

On the inside of the lid. It might take a little elbow grease, but yeah. Should work

Haha. It's aight. :P

You shoulda debadged too .Oh well good start though

I did have it debadged... didn't like the look.. guess it's just a matter of opinion. now i have to get the bumper fixed.

I kinda like how the back where it says pontiac is white and not gray...

yeah. i have a felling the guy that owned it before me got rear ended and just fixed it himself. reason number one: the paint job on the bumper is terrible. number two: as you stated above that the pontiac part is painted white. number three: i can't use my key to open the trunk. and i know for a fact it is not the valet key.