Sven the Sexman
GrandPrix Junkie

PARTS LIST: LIM GASKET, ARP HEAD STUDS and FEL-PRO HEAD GASKETS(if I need to pull the heads ), YT ROCKERS & PUSHRODS, LS6 SPRINGS,ARP ROCKER BOLTS, MANLEY VALVE RETAINERS, VITON VALVE SEALS, JP TIMING CHAIN, DAMPENER, LS7 LIFTERS, ZZP GT1 CAM. I just replaced the valve cover, throttle body, and UIM gaskets as well as the upper and lower Injector O-rings. I figure I can work on the valve train while you are working on the cam. oh, also, I need your address so I can get that HPT delivered to ya!

gotcha! the one I saw on ZZP was around 800. I'll PM you my parts list, you let me know if I need to get anything else k? Thanks Jason!!

O.K. found it ( I think) So its around 800 yes?

Hey Jason! I was hoping to pay you a visit the week of November 5th to get this cam installed. I'll also need a tune to go with it. How much would you want for the install & tune?

Hey Jason...I'd like to make a donation for the meetup on the 27th...Lemme know what you need K?

Man, sorry to say but I am gonna have to back out of the Halloween party. Work just booked a breakfast party for the 28th. Was really lookin forward to meeting everyone! Hope to catch the next group meeting.

Count me in for the Halloween fest!

I finished the compression test. Cylinders 2,3, & 5 read 160 psi. Cylinder 4 read 140 psi. MUCH better than the last test. I used a new test kit this time rather than the old (and obviously faulty) kit at the hobby shop. I noticed that both of my valve cover gaskets need replaced so I'll do them when I check the 2-4-6 valve train. Could it still be the piston rings? I am seriously (and HAPPILY) doubting that at this point. Doubting a head gasket as well with the test results for the #2 cylinder. So I am guessing that it is a worn or damaged valve, valve spring, valve seal, or lifter. Does this sound about right? Anything I am overlooking? My brother said to check and make sure that the oil ports to the valve train aren't gummed up or blocked.

Holy crap! I got a visitor message! I feel like I'm becoming somebody on the forum!! LOL

Hey Jason, if you have a minute, could you read my last post on my "Good Ole' P0304" Thread and tell me what you think?