Surprisingly, the crank didn't look too bad. I think I stopped driving it just in time. I spent about $20 on wet/dry paper, metal polish and some shoe laces. I think for what it is, it will be just fine. This is the worst journal after polish.
|
|
05-31-2022
Surprisingly, the crank didn't look too bad. I think I stopped driving it just in time. I spent about $20 on wet/dry paper, metal polish and some shoe laces. I think for what it is, it will be just fine. This is the worst journal after polish.
06-01-2022
your no dummy so im sure your going to measure the journals as well as bearings installed with caps installed and torqued. then plastiguage the bearing when the crank goes in for the first time to make 100% sure your in spec.
it would piss me off to no end if i cut them corners and it failed in 200 miles.
tomsteve liked this post
06-01-2022
Oh, yeah. I'll check everything as it goes together. Biggest thing is how the crank spins after it's torqued. Hand tight and the crank won't spin freely. After all the mains are torqued, it spins like butter.
Tonight I got the AC lines cut and crimped. Also vacuumed and filled the system. It blows pretty cold just idling in the driveway on a 95 degree day. I can't wait to see what it does on the highway with a ton of airflow. Buying the crimping tool was definitely a good investment.
Scottydoggs liked this post
02-28-2023
I picked up this little gem today. 32 spline input shaft for a 208c T-case. I'll need it if/when I go to an 80e. It will happily sit on the shelf until that day comes.
02-28-2023
id have that oiled up and in a food saver bag all vac packed.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
