Thread: Scottydoggs regal GS 2.0

thanks to some scum bag deleting my thread, heres the short version lol

bought this beater for 800. back in 2010



tinted tails and spoiler added as well as window tint.



scored f body brakes and ss lines



replaced seats with those from a 01





scored sts wheels.



fixed and painted rear bumper.



found a set of wheels with snows.




re painted front bumper, cause they needed it bad lol

then mods happened.

1.95 rockers and springs.



and headers




then a 3.4 and a dhp

and then this asshole showed up



so a l36 was found, another set of l67 heads that got diy porting with the rockers headers and a ic added a few months later.



stripped down l36



head work



painted



out with the old.



the new



new installed






then a ic install






then the tranny took another sh it, aka number two. went full new rebuild

out with the old crap again





new tranny

and a crap load of new parts all around, cat backs, r1 brakes, all new front suspension crap, rear sway bar up graded. BS left and right added over time.

http://s1097.photobucket.com/user/sc...?sort=3&page=1 heres the whole folder.

and to be deleted again in 6 months!

more new sh!t installed

its 98% installed its all wired up, everything is mounted up. only thing left to do is figure out where to drill tap and mount the nozzle, and i need larger eyelets for the neg and pos wires at the battery. and cut a vac line and install the T, new vac line is also ran as well as the tube to the engine bay for the meth.

the kit came with a new led light to mount but its smaller then the one i already installed in my pod, i reused the one in there already.

Wut Wut, Meth injected directly into blow............er.

lol

water meth injection kit. http://www.jegs.com/i/AEM/017/30-330...62FxoCHRrw_wcB this is the first link that came up, i didnt pay this much lol

on paper, pretty much lol it should make you able to run more boost and more timing, i need more of both for sure.

awwwwwwwwwwwwwwwwwwwwwww **** honey

meth install complete.

i just took 5% out the maf top end, added a degree of wot timing, set the meth start spraying at 4 psi and went out and let her rip...... no kr pulled pretty damn good wb said 11's might take a bit more fuel out the maf. only made about 10.5 psi, so why not try the 2.8???? i already have it, so f it right lol

i did have to mod the zzp tb spacer. i pre drilled the hole to be tapped, then took a notch out of the front side of it so the tip is about flush with the spacer inner wall.

no pics yet, other then a mounted injector and blue stuff in the tank now lol

What was the seat of your pants dyno rating? :P