|
|
04-27-2013
hi it's just another random question. I went to use my washer fluid today and realized my windshield wipers only work on the highest level. Also when I try to stop them they stop immediately instead of going back to their original position. also when I push the button for the fluid it sprays but it does not move. I checked my fuses and I can't seem to figure out what the problem may be. thank you very much I appreciate it
04-28-2013
Maybe the motor for them isnt working right. Its not hard to replace but I dunno what they cost
04-28-2013
could be the multi switch. being it controls the speed and washing.
everything else work on the arm, blinkers, cruise, high beams, and hazard lights?
04-28-2013
The wipers have their own arm on 04+ carsOriginally Posted by Scottydoggs
04-28-2013
yes everything on their works perfect aside from the low levels of wipers. it's almost as if there isn't even a motor there it doesn't make a noise or anything
04-28-2013
Get a volt meter and check for current at the motor when the switch is on one of the low levels where it doesn't work
04-28-2013
Switch is what I usually see when this happens. You move the switch all the time especially if you're like me trying to dial in the perfect wiper speed lol.
04-28-2013
Switch or motor. The motors have logic if the board is junk it'll do the same thing. I can pull a diagram for you and just test for grounds coming out of the switch on each setting.
Sent from my Galaxy SIII on Tapatalk 2
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
