|
|
04-15-2020
Hey guys!
I just bought an 06 base Grand Prix for $200 to rebuild, pretty much done and ready to put the engine back in... and for some reason, I can't remember where I pulled these from!
Also, I cannot seem to find replacement exhaust studs anywhere...
Would anyone have any ideas? (Digital) beer is on me!
04-16-2020
i think the one on the left is the MAP sensor bracket that bolts on the rear top of the LIM
04-16-2020
Thanks! Pretty sure that's it... Also, figured out what the circular thing is (motor mount of some kind).
I really appreciate it!
04-16-2020
larger part the bolts to the lim on the left side side of the engine, leads tot he dog bone mount on the rad support. you got the bolts in the wrong side, they go in from the other side, then that part goes over the valve cover pretty tightly. but not touching.
04-16-2020
looking back at your dog bone, the new engine come from a H body? might be the single upper dog bone they have.
04-16-2020
Actually, it's just a pull and rebuild, so my engine should be original to this W body.
Thank you guys for all your help!
Funnily enough, I'm still trying to figure out the L shaped bracket.
04-16-2020
That small bracket is part of the EGR mount. The large bolt with the torx mark in the top goes into the LIM/head right around the middle cylinder in the back. Look close to the injector for cyl #4 and you should see it. Under the fuel rail. Once you lay it back there you should be able to tell where the rest bolt to.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
