My seatbelts in my 99 work with it, but I will most likely swap them out to the 04+ ones eventually. I remember at least one member mentioning they had done this. Now I just need to get another set of headrest seatbelt holders again.what about the seat belts, can the 04+ ones bolt right into the 97-03 models?
Sorry, I didn't see your questions earlier. I don't check this thread very often. I am unable to update the write-up so it has just sat. The CGP one is updated more, but needs to have more.can anyone elaborate a little more on how to hook the wiring up a little better, I'm having trouble trying to figure out how to connect everything,
Am i going to be splicing and making my own connections or ....??? pictures would be excellent if possible
Don't know if my passenger side heat would be the same for anyone else since I already had an aftermarket heat kit in my old passenger seat. I have bigger things to tear apart before I get back to the interior.
Here is the wiring part of it to this point.
Wiring:
99 GP (Connector c311)
--------------------------------
Pin A-Fused Battery Feed - Orange (larger gauge wire)
Pin B-Ground - Black
Pin C-Fused Battery Feed - Orange (smaller gauge wire)
Pin D-Seat Belt Switch Input - Black/white stripe
Pin E-Heated Seat ON Feed - Blue
Pin F-Heated Seat Low/High Input - Pink
05 GP (Connector c311)
--------------------------------
Pin A-Battery Positive Voltage - Orange
Pin B-Driver Heated Seat Cushion Temperature Sensor Low Reference - Yellow
Pin C-Battery Positive Voltage - Orange
Pin D-Driver Heated Seat Relay Control - Purple
Pin E-Heated Seat Cushion Temperature Sensor Signal - Yellow/black stripe
Pin F-Not Used
Pin G-Ground - Black
Pin H-Seat Belt Switch-Left - Black/white stripe
Pin J-M-Not Used.
Connections:
Pin A to Pin A (+)
-Orange to Orange (larger gauge wire)
Pin C to Pin C (+)
-Orange to Orange (smaller gauge wire)
Pin B to Pin G (-)
-Black to Black
Pin D to Pin H (Seat belt)
-Black/white stripe to Black/white stripe
Pin E to Pin D (heated seat on feed/Driver Heated Seat Relay Control)
-Blue to Purple
Pin F to Pin B and Pin E (Heated Seat Low/High Input/Driver Heated Seat Cushion Temperature Sensor Low Reference and Heated Seat Cushion Temperature Sensor Signal)
-Pink to Yellow and Yellow/black stripe
If you have anything to add or pics it would be very welcome.Original: tviolette76
Well the seat switch has been turned around and it works great. I did have to shave/cut off three plastic tabs (guide tabs) that I found to be a non issue. Two of them are on underside of the switch cap (for lack of a better description) and one on the switch body. They are very easy to see when you do try to reassemble the switch, and just by taking a knife to them to slice them off is required.