Thread: Blend Door Actuator Replacement

So the vents on the drivers side blow hot while the passenger side blow cold. Common sense tells me that the drivers side needs replacing but common sense isn't always the way things work with these cars. Also is it the same part for both driver and passenger side or are they different. I'm only seeing one part listed on Rockauto. Figure I might as well replace both of them while I'm at it.

if its not as cold on the driver side you might need a re charge.

you can take the actuator back off turn the knob by hand to see if its blows full cold as well. thats a free test at least.

i feel your pain, mines only held on with one little bolt now lol


and i wear size 3x gloves too. dont help any.

Where is the blend door temp actuator for single zone manual control for the 1997 GTP ?

Has anyone tried this method ?

Originally Posted by Kscottm

A helpful tip when pulling out that drivers side actuator (97-03). After removing the carpeted board above the pedals and the plastic panel below the steering wheel, pull off the black metal bracket the aforementioned plastic piece was attached to (four bolts and a couple screws). This gives you a straight shot to the LH blend actuator (I'm 6'5" with big hands and was able to get in there with little issue). Use a 7/32" deep socket to remove the three small bolts from the actuator and unplug (no extension or ratchet required). Once panels are out, should only take a couple minutes to pull the actuator! Hope this helps...

i took all that off, all it did was let me see the actuator while peeking through the crack, lets you find the little bolts easier, thats for sure.

thanks, does it matter if the tilt wheel is up or down ?
Does this mean the actuator is close to the steering column ?

I thought it was by the center console above the gas pedal ?

Anyone have a picture or video ?

http://www.grandprixforums.net/threa...or-Replacement lets read page one, post one.....