I just hooked up a new blower motor resistor after i finally lost the max setting and when i tried the heater nothing. could the blower its self be bad i did not have the resistor mounted would that make a difference? Thanks
|
I just hooked up a new blower motor resistor after i finally lost the max setting and when i tried the heater nothing. could the blower its self be bad i did not have the resistor mounted would that make a difference? Thanks
Its possible that your blower motor is bad, check to see if you have power to it. Check your fuses. That is where I would start.
Seeing as how you said you replaced the resistor, I would bet that it might be a possibility that your switch went bad.
I have also seen on here where folks have said that their ignition switch was the culprit, so keep your mind open to that possibility as well. Good luck.
Last edited by Blown97; 11-16-2008 at 01:43 PM.
I have checked all my fuses and none were burnt out. I lost the blower motor once before and it came back like 2 days later if that helps and i also pulled the park lock thing a few days ago before i lost the blower motor. I will try to find a thread about the ignition switch. I am going to pull the blower motor on monday and run some leads to it to see if it works
Yeah it might help. You could have a bad spot on the actuator on the blower motor. With the power to the motor on, try tapping the blower motor with a screw driver handle and see if it turns on.
And like i said, before you pull out the motor, check the plug that plugs into it for power.
That is the plug coming from the resistor right ? or is there another one hidden somewhere ?
well you could try that one too, but I'm talking about the one that goes to the motor too.
Oh sorry i meant to say the plug in the blower motor that has the wires going to the resistor
Wow i am an idiot i had the wires from the old resistor plugged into the blower motor now i just have to wait till tomorrow to get my tools so i can take the old one out and get the new one
« Previous Thread | Next Thread » |
Tags for this Thread |