Thread: P0102

Results 1 to 16 of 16
  1. #1 P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    02 Gp Gt 142kmiles.
    My car has his maf code, I cleaned the maf didn't work. Swappped 2 difmaf. Didnt Work. It itl, idle rough for a few mins. Then dies bak to normal after a little with an occasional hiccup. My traans is going out. But it runs normal unless I decide to get on it orim goinup a hill riding between 45-50mph then it'll start boggin unless Iet it stayi 3rd. Shifts between 2500-3100rpms normally. Ahyways bak to the code. I changed my ttb gasket cuz there was a gap between thetb and the uim in a spot. But I cnt feel any airleaks. At all. The gap is still there I plan on combining the tb gssket with rtv for a failsafe. My idle sounds like a v8 imo and my friend thinks so as well. Could it be my cat or egr.? I took my air box out cuz it leaked nd now it has the spectre hai. Started it. Cel was gone. Letit run for a few mins. Shutit off. Came back. Started it to my friend., a min after running CEL came right back on. What else can it be
    Reply With Quote  
     

  2. #2 Re: P0102 
    Moderator dsmuts's Avatar
    Join Date
    Feb 2011
    Location
    Coldwater, OH
    Posts
    15,758
    Thanks (Received)
    1
    Likes (Received)
    1
    Dislikes (Received)
    0
    Check the wiring to the maf.
    98 GTP modded 1.9's, sd headers, 3.4", zzp 1.0 230K miles scrapped.
    04 Comp G zzp stb's, UMI ta's, Speedbuilt sways, bully flo heads, XP, zzp headers, fsic, thrasher shift kit, 60#, 2.6" corsa 2.5", Inferno hood
    01 gt z7 turbo tep trans zzp motor
    08 g8 gt cam exhaust 11.87@118
    Reply With Quote  
     

  3. #3 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Me and my brother did. It all looks good. No kinks or anything.
    Reply With Quote  
     

  4. #4 Re: P0102 
    Moderator dsmuts's Avatar
    Join Date
    Feb 2011
    Location
    Coldwater, OH
    Posts
    15,758
    Thanks (Received)
    1
    Likes (Received)
    1
    Dislikes (Received)
    0
    Check your fuse under the hood. It's IGN or something like that.
    98 GTP modded 1.9's, sd headers, 3.4", zzp 1.0 230K miles scrapped.
    04 Comp G zzp stb's, UMI ta's, Speedbuilt sways, bully flo heads, XP, zzp headers, fsic, thrasher shift kit, 60#, 2.6" corsa 2.5", Inferno hood
    01 gt z7 turbo tep trans zzp motor
    08 g8 gt cam exhaust 11.87@118
    Reply With Quote  
     

  5. #5 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    I'll do that tomorrow. Nd chek bak in.
    Reply With Quote  
     

  6. #6 Re: P0102 
    GrandPrix Junkie gtpeddie's Avatar
    Join Date
    Jan 2012
    Location
    Philadelphia
    Posts
    3,895
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    I got the same code and similar problems still trying to figure it out

    97 GTP DD, 1952 Ford F-1 Resto Project, 2006 Mustang GT "UnDeR CoNsTrUcTiOn", 02 GPGT SOLD!, 98 GTP Parted/Scraped
    Reply With Quote  
     

  7. #7 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Quote Originally Posted by gtpeddie View Post
    I got the same code and similar problems still trying to figure it out
    I saww. I've had the code for a while. Always assumed it was my maf. And didn't carem my gss mileage never went bellow 20. So it didmt seem like my mpgs suffered. From wat I've read tho.. I might have a clogged cat. But my cel doesn't flash..
    Reply With Quote  
     

  8. #8 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    And since I have a cel on.. I fail emissions and my plates expired. So I've been riding dirty for a while now
    ..I made the 06 look like 08 so if a co p looks from a distanc http look like I gt till the end of august..lol
    Reply With Quote  
     

  9. #9 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Checked it. Looked rough.. couldn't tell if it was bad or not.but replaced with a spare to be safe. Light didn't go away, but it seemed to start better.. lol
    Reply With Quote  
     

  10. #10 Re: P0102 
    GT Level Member
    Join Date
    May 2012
    Location
    Albuquerque, NM
    Posts
    294
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Quote Originally Posted by GPTAFan View Post
    And since I have a cel on.. I fail emissions and my plates expired. So I've been riding dirty for a while now
    ..I made the 06 look like 08 so if a co p looks from a distanc http look like I gt till the end of august..lol
    I'll assume you already know this but I'll say it just in case you don't, falsifying or altering government issued identification is much worse than the petty misdemeanor of expired plates. I'd just run expired instead of altering them. Bad bad juju there...
    Reply With Quote  
     

  11. #11 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Yess I knoww. Lol I I didn't have a problem so farr. My mom came home wit temp plates today. So I put that on.
    Reply With Quote  
     

  12. #12 Re: P0102 
    GT Level Member
    Join Date
    May 2012
    Location
    Albuquerque, NM
    Posts
    294
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Just trying to help a fellow out.

    Still interested in what is causing the issue. Keep us updated!
    Reply With Quote  
     

  13. #13 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Quote Originally Posted by slimguns View Post
    Just trying to help a fellow out.

    Still interested in what is causing the issue. Keep us updated!
    Still haven't figured it out.. since thelight was off for a little I have a few sensors to switcharound to see if the light goes off again.. I'll do that later. I've been busy hanging with a girl the past week.
    Reply With Quote  
     

  14. #14 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    Almost possitive I have a clogged cat... at idle my exhaust feels like someone blowing hot air with there mouth wide open..only rlly hott
    Reply With Quote  
     

  15. #15 Re: P0102 
    GT Level Member 40th GP's Avatar
    Join Date
    Oct 2010
    Location
    Utah
    Posts
    198
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    What ever happened with this?
    Reply With Quote  
     

  16. #16 Re: P0102 
    GT Level Member GPTAFan's Avatar
    Join Date
    Sep 2012
    Location
    Maryville, Illinois
    Posts
    228
    Thanks (Received)
    0
    Likes (Received)
    0
    Dislikes (Received)
    0
    The right muffler might be clogged.. idk my right tip doesn't flow as good as my left. But I haven't gone any further than that. Been working.. I have gaskets all way down to LIM and a new UIM from zzp. Just.. finding time to do it.. and I wanna make sure I have it all covered and ready to do..cuz I usually dmt have much time between work the girl. And I need to get 2 new tires. Lol

    Ultimatly. Not solved. Yet
    Reply With Quote  
     

Similar Threads

  1. code p0102
    By 98pont in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 1
    Last Post: 05-07-2013, 05:36 AM
  2. p0102 code help
    By dsmuts in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 3
    Last Post: 02-17-2012, 06:47 PM
  3. P0102 need help after change!
    By biggt in forum General Tech Discussion
    Replies: 6
    Last Post: 08-29-2011, 11:46 PM
  4. p0443 and p0102
    By Lawngoose in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 10
    Last Post: 10-04-2010, 03:21 PM
  5. code p0102
    By hunter_alexander in forum 3.8L V6 Supercharged (L67)(L32)
    Replies: 2
    Last Post: 05-25-2008, 12:09 PM
Tags for this Thread

View Tag Cloud

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •