|
|
12-26-2012
I have recently swapped a 99 buick park avenue ultra l67 motor/trans into my 98 GP GT used my l36 harness, spliced the wires for map sensor an got everything ready all im lacking is a pcm. My question is what pcm will be a plug an play deal for what i have.
I have also been told but not sure if its true that if i was to have my vin programmed into a l67 pcm that it will change the l67 pcm settings back to the l36 settings is this true?
Thanx for any help!
12-26-2012
zzp has what your looking for
12-26-2012
The only down fall to that is I can't get anyone on the phone
12-27-2012
You can have a someone program your vin into a ecu but it will set that ecu into what you computer was set as for what the car came with in from the factory . Someone will have to go through all the files and adjust them .
I ran into this problem when I did the swap you did . I ended up getting a friends vin number off of his 2000 Gtp and had a company program that into a ecu so that I could at least have a stock Gtp file .
You could also maybe find a 98-02 ecu from a junk yard out of a Gtp and slap that in .
12-27-2012
I was thinking about just getting a used pcm from a junk yard like you mentioned but zzp's pcm isnt all that expensive either. i will prolly end up with a salvaged gtp's pcm should still go through inspection as long as i dont do it myself they shouldnt think im trying to clean scan it lol
12-27-2012
just checked out zzp's site an looked at the 1.0 pcms like you rec. erik. that will deff be where i get my pcm from thanx for the advice
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
