Started yesterday and took out a good bit but now I'm needing to smooth out and tweek a couple other areas. Any advice and constructive criticism is greatly appreciated.
I haven't done anything with the inlet yet.
|
|
03-17-2011
Started yesterday and took out a good bit but now I'm needing to smooth out and tweek a couple other areas. Any advice and constructive criticism is greatly appreciated.
I haven't done anything with the inlet yet.
Last edited by benner; 03-20-2011 at 10:05 AM.
03-17-2011
Looks pretty good. Just do a little smoothing and you're done
03-17-2011
x2
03-17-2011
maybe it's the pictures, but it looks like you took too much out.
03-17-2011
add a nice bevel.
On the intake you can't do much.
the PCV system is in the way.
At least right near the rotors, closer to the TB you can do a little.
03-17-2011
Okay just finished the supercharger and LIM. Ended up just removing the casting marks on the inlet of the supercharger. So tell me what you all think.
Just a bit of water on the flat area.
And here it is with the old gasket on it.
Also broke this sensor. Guessing it's the coolant temp sensor?
03-17-2011
yessir.
03-20-2011
Finished it up Friday night and. Honestly the best single mod I've done. Throttle response is so much snappier and my gas mileage is up. Was down averaging around 22mpg highway and now its back up to 27mpg after 80 miles of driving. Also interesting is that I picked up about 1psi but that'll drop with the headers
My speed daddy headers should be arriving tuesdayy so they'll hopefully be on tuesday or Wednesday night
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
