|
|
03-22-2009
I have to get my emissions done by Friday, 3/27/09 or else my registration will be revoked.
I haven't been able to fix code P0102. Low sensor circuit frequency to MAF.
If I disable the emissions codes so I can pass emissions is there anyway they would find out?
What are the potential consequences if I get caught? Thanks
03-22-2009
if you disable the codes they wont show up so you will pass, but why dont you just get a new MAF if you need one?
03-22-2009
Be aware, writing the PCM will cause the emissions test to reset, so they have to rerun, and that could take a couple hundred miles. You'll fail until they complete.
03-22-2009
if thats the case then i will rewrite it tonight and i should be more than fine by Friday.
Would that work?
I will be getting a new MAF but funding for repairs are a little tight. im doing fine with the map sensor and im not going WOT so for now im just worried about saving $128 to re-register my car.
Last edited by Quicklynx; 03-22-2009 at 12:18 PM. Reason: spelling errors due to stupid phone
03-24-2009
where are you located? i know in ontario canada the engine light and codes dont matter for an etest they will still run the test with it on. I used to do them and you might not fail. Over 40% of the tests i did all had engine lights and codes and most of them still passed
03-24-2009
for those that are skeptical, i just got my emissions tested today and i have no EGR, but the codes turned off. i also dont have a VIN that matches my car in the PCM. i passed without even trying.
03-24-2009
That wouldn't pass in CanadaOriginally Posted by Bio248
03-24-2009
Yup I called around and you need the EGR almost 100% of the time, but I have someone on the inside...haha!
03-24-2009
Yea all my codes are cleared.. I run a scan on my laptop and nothing comes up.. the SES light is still on however. Last time I failed the SES light was on and they still ran the test.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
