Winter is here and my hot air takes a while for it to get hot I know there is air in the system because my upper coolant line came off 2 months ago I want to do a flush to get the trapped air out how hard is it to do on my car ?
|
|
11-28-2015
Winter is here and my hot air takes a while for it to get hot I know there is air in the system because my upper coolant line came off 2 months ago I want to do a flush to get the trapped air out how hard is it to do on my car ?
11-28-2015
Grab a dictionary and look up the word "Easy", that should explain it pretty well.
A short and too the point flush would be remove both rad hoses, both heater core hoses and remove the thermostat. Take a hose and spray water through the rad, into the intake manifold and through one heater core hose/then the other. Slap it back together, fill through the thermostat hole and rad, then install thermostat and start it up and let it run. It should bleed just fine with the cap off.
12-02-2015
ok thanks going to do the flush tomorrow
01-29-2016
did the flush didnt take to long another question my passenger floor is always wet could the ac drain line be clogged and if so do you know the location of it
01-30-2016
Right here:
03-08-2016
jacked up the passenger side tonight and took off the wheel and seen the little rubber elbow can i get to this from the top tryed to get it with the wheel off no luck ??
03-08-2016
You ain't going to you have to come up between the subframe
03-08-2016
OK thanks
03-09-2016
Wet passenger side floor is usually caused by water dripping in from the cowl. You can get an updated part from the dealer, Amazon or eBay for around $10 and it takes 20 minutes to replace if you're slow. There are a couple of write ups on here, I believe in the "how to" section.
03-09-2016
The sooner it's taken care of the better because it goes through your blower motor. Mine did same thing 8 months later blower motor eats sh!t
03-10-2016
Is this what your talking about the deflector #15794785 I just did that last week
03-10-2016
Yes, that should have fixed the wet carpet on the passenger side. Some recommend that you also replace the blower motor/fan assembly as well since water has been running through it.
03-11-2016
the carpet is fine now just damp and would the blower motor/fan be going in the car sometimes dosent work till i hit a bump then turns back on and roughly how much is the blower motor and fan ?
03-11-2016
40 on AmazonOriginally Posted by gordster1122
check rock auto
03-12-2016
do i need a new resistor to ????
03-12-2016
I replaced that first and it was the blower. I just left it in for world peace.
I bought the TYC from Amazon. It has a strange whine that elevates with speed. Works fine.
The Delco I believe from RA is about 80 and no doubt would be whisper level like the OEM.
Do one at time if you dont care and find out which is the problem. My blower would start fine but then slowly slow down after it got hot.
Getting water on it in the past didn't help the motor much. The resistor is pretty much out of the water path.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
