|
|
08-14-2015
Any reason these would not work?
https://southbend.craigslist.org/pts/5113001435.html
http://www.discountedwheelwarehouse...._Reference.cfm
I am looking for some cheap 17's. I really like the split 5 spoke wheels that came on newer Grand Prix.
Any suggestions on wheels? I want something fairly light and kinda like the idea of factory wheels.
08-14-2015
if those are they same wheels they put on the 4 cyl 2010 Fusion SEL, which I think they are because that's what my wife drives and they look the same, you don't want them because tires are more expensive for that size. we looked around last fall for new snow tires and ended paying 700 for a set, and those were about the cheapest ones we could find. its an odd size that doesn't have a good selection of tires.
08-14-2015
I don't think he's putting them on a Fusion, he's putting them on a Grand Prix so he could use 225/55/17 which runs from $100.
08-14-2015
That is correct. So you guys think they would work fine on a Grand Prix?Originally Posted by stealthee
Better yet sell me those 17's off yours!
08-14-2015
i got 17's for my snow tires. i kinda hate the ride quality. iir mine are 50's tho so a bit thinner sidewall.
08-14-2015
Check the centerbore on the fusion, I want to say it's too small.
08-14-2015
Just checked, I'm finding 67.1mm for the Fusion and the GPs are 70.3mm. So they won't work
08-14-2015
I was gonna say, it looks darn close, but for sure measuring or test fitting is in order.
08-14-2015
3mm in the world of hub bores means not fitting unless you modify the wheels.
or run a stupid amount of spacer.
08-14-2015
Too bad. Those are sharp wheels.
Go Ford for always producing good looking wheels.
08-14-2015
or a friend like Jeff with a milling machine.
08-15-2015
Like the ones on my car?
I got em for 150, and had to buy two new tires.
), heated leather, autostart.
08-16-2015
LOL, my lathe is only 9X19 and the milling machine is only 7X18 so I would have to have a rotary index table (I'm working on it), to do it on the mill. I'm already trying to get them to get a larger mill and Lathe. "I think we've outgrown them".
Jeff
08-17-2015
this is something you could probably accomplish with a dremel if you wanted it enough.
| « Previous Thread | Next Thread » |
| Bookmarks |
Bookmarks |
