Thread: What did you do to your car today? Vol 2.0

Its a 35mm also anyone remember me conplaining about the caliper slide bolts being seized..... well i ****ing knew it....



Also the balljoints on both my dorman LCAs are torn so mad right meow. Im ignoring the balljoint for now but I'll need too do them again sometime.

Also found my crappy braking issue, i think that bolt was broken for a while but hard too say

time for some f bodys. return all that new stuff and up grade it right now lol

Nope, im not going to keep my car down while i source them plus i already got pads and rotors. Im just going to get some from advanced tomorrow and then hope the axles go smooth.

fingers crossed. you dont want to be captbreaksalot do you now?

Yep thats been busted for a while! Find a cool beverage, re-assess. You need more parts now right? That bolt stump is a mess, man. Luck to ya.

The other side I almost broke it was hardly coming out, took breaker bar + pipe. At least they look good and 4x4...

all that and no caliper paint? come on.......im a ball buster today aint i?

Im so done with today i dont even care haha, i wanted too paint em but was lazy. I have some guy wanting too look at the trans am tomorrow and i just don't have the time. If i didnt already take an hour too go to orileys too get the rocket axle nut socket i would have picked one up. Screw living in BFE 30min 1 way too town.

Last of me spamming this post, my old fluid was nasty green now its all better.

i got one of them DIY one man bleeders. they work damn good.

i use a water bottle, get a new bottle take its cap, toss the old fluid, use the old cap with a hole on the new bottle.

Thing is the pedal feels spongy now, so idk what happened. Maybe because the fronts aren't done yet? All the air should be out of the system for the most part at least rears. The res never ran below the "low" line.

1/2 a set of new pads will do that as they break in.

Well i havent driven on them yet but just moving the car back and forth to settle it the pedal felt soft compared too before. Im gonna bleed them again while i have my grandpa pump the pedal. After i get done

Done til Monday...well probably next weekend.

Yea, I've had back problems lately and they help it quite a bit. They're like flip flops for someone with a bad back, lol.

The usual... GTP wash and vac. Plus air filter service. Bonus pic of Godzilla's playpen to make everyone feel good about their cars!

Got groceries in the GT. Peeked under it and realized its missing a left sway bar link of course. Tire can rub. Think I'll swap frames. Mebbe hunt for alum.

Make sure you get one from something that's 01+ they have stronger welds. The older ones are known to crack.

http://www.chilsonwilcox.com/autoche...1#full-history

I bought that today. 07 base model 134k miles, engine and tranny are great, has a wheel bearing issue i think, my abs code showed wheel speed sensor on front right. Made noise when going to left on highway, thought it was right rear wheel bearing but not sure. got it for 200$ less than trade in value, 3300$. Has no rust at all on it.