Thread: What did you do to your car today? Vol 2.0

hypalon roof in SD? what a pos that is. ( how can i tell?) lol its white, its plastic roofing thats heat welded together at the seams and mechanically fastened. once it gets cold and a snow load hits it, it just gets tore up good.

thats a south roof, places where it dont rain much, or snow.

same crap on sams club, but its older.

< Hates Walmart

Rather pay a few bux more and go to Target and make it a quick in and out trip.. No matter what time of day it is seems like Walmart never has enough registers open


Sent from my iPhone using Tapatalk

they've got like 40 check out lines in the sh*tmart here and only ever open 3 or 4

Originally Posted by ScottyDoggs

hypalon roof in SD? what a pos that is. ( how can i tell?) lol its white, its plastic roofing thats heat welded together at the seams and mechanically fastened. once it gets cold and a snow load hits it, it just gets tore up good.

thats a south roof, places where it dont rain much, or snow.

same crap on sams club, but its older.

Oh it leaks lol

Sent from A Galaxy Far Far Away

Originally Posted by EHBGoober

they've got like 40 check out lines in the sh*tmart here and only ever open 3 or 4

That's every Walmart. But ours has self checkouts so that helps a ton when you just need a couple things.

Sent from A Galaxy Far Far Away

Yup thats how it was tonight, like 35 registers total, and maybe 5 open. Long lines at every one. The self checkouts had a line of 3 people maybe, but there are 8 there (7 working). They don't use cash though, credit/debit only I believe.

Originally Posted by Slick2500

Oh it leaks lol

Sent from A Galaxy Far Far Away

not surprised one bit lol

When walmart opened here they promised to open more lines when 5 people got in a line. That lasted the first year.

Got the water pump in and snapped the bleeder. No leaks which is good and no air trapped in the system which is better Also i figured out the power steering bolt different from the water pump bolt (btw took me seconds to line the bolt up) because i tried using it on accident and almost snapped it. The water pump i got looks to be a better design? Its cast with a different impeller design but from what I'm not sure. A reviewer said iron but idk.

I don't know if I would consider the new one a better design, but then again I am not an expert in fluid dynamics.

As for the bleeder, I snapped mine once too. Advance carries them. They are relatively cheap and you get two in the package.

I didn't have to use it much before I snapped it luckily the system didnt really need bleed at all lucky enough. Yeah idk about the design either, doesn't the Meziere Electric WP have a similar impeller?

Finally got color and clear on the engine bay of my Stealth

Its not hard to do. I didnt even torque it that tight when it snapped on me. Luckily it snapped flush so nothing could leak.

Mine I literally wasn't paying attention, I was tightening it while looking a torque to watch temps while explaing to my grandpa I had a dentist appointment in 30min and snap. Whoops lol

i deleted every code there is to pass inspection vs waiting for stuff to become ready.

lookin good sealthee

Originally Posted by EHBGoober

lookin good sealthee

+1. Fresh! Nice loud blue, I can dig it.

I mopped layers of mold off the Grape Turismo Obesemo, til dusk. Rare on a Tuesday. Therapy lol. Might take her out in daylight tomorrow, a couple fngs at work never seen it. Now that Betty has a black arrowhead I can't see her from as far down the street at night wah.

picked up a throttle body gasket. might tear the TB off and clean it sometime this week...or next.