Thread: What did you do to your Car today?

I almost had the front end of my car taken off by some stupid ****ing teenager in an astro van thinking he was Vaugh Gitten Jr.

Just got the Trans-go shift kit, i bought my self as an xmas present...



not gonna lie. I'm a tad nervous about the install..

It's easy peazy

thats what i'm hearing...

i hope it is?

i'm sure there's a how to floating around in here somewhere..

veryyy easy

4T65E Do-It-Yourself Shift Kit: Instructions and Install Guide
Shift kit install, very detailed (56K go watch a movie) - LS1TECH
Trans Go Shift Kit Installed - First Impressions - LS1TECH

Installed new valve seals,105 springs,and yella terra 1.9 roller rockers...and crushed a sharpy in cylinder 5.

Originally Posted by HVACgtp

If I had the place to do good work like that I would deff try it, but living in the parents house and step dads a dick and the garage is a mess, I has no room lol I was working ontop of a table saw, that's why the bulb broke, got caught in the plate of the saw top lol

i hate when there's no room. luckily my dad has a huge heated shop with a hoist and all for work.. but even in there there's plenty of s*** everywhere.

Originally Posted by marines542

Just left dealership and got a free spare tire and rim from a bonne gxp cause they couldn't find the one for my car. Also free alignment and tire balance for new rim....that'll teach them to f*** me over

Sent from my pager using Morse code. ... .. ... ....

I need to some how get them to f*** me over and then get free s*** like you. i need a spare!

Originally Posted by jerZcavy4120

Just got the Trans-go shift kit, i bought my self as an xmas present...



not gonna lie. I'm a tad nervous about the install..

need to do that too when i change my TF in few months after i start driving the GP again.

Originally Posted by marines542

i would prefer not to get f***ed over anymore. and as for the spare the gxp's did not come stock with one but when i bought the car i told em i would buy the car if they did a few things. a spare put in would be one of those things but the put a 4 lug spare in not a 5 lug one. but i also got the parts order guy to believe that the correct spare for the car is the same as the 17x4 spare from a bonne which will work on our cars. well thats what they ordered.

i wasn't serious when i said i wanted to get f'd. i just need to find a spare some where for cheap. always hesitant to drive a ways.. i blow a tire i'm SOL.

Lent a hand to my bro installing his 3.4 pulley on his 03 top swap.

Originally Posted by jerZcavy4120

Just got the Trans-go shift kit, i bought my self as an xmas present...



not gonna lie. I'm a tad nervous about the install..

Use six sided sockets

Shift kit is just messy,lots of tranny fluid from a wide swath. Everything else is just unbolt, play with,bolt back up and add fluid.

It's not to messy if you are careful

Lol im not.I usually need a nice piece of carboard to line the gound and a large foil pan to catch the fluid the way i do it.But at least the ground stays clean

I use a large tupperware container now thanks to Mr bill

I feel so damn abusive to my babies lol

I tried starting it today, but the only thing that is happening is a spit and sputter every few seconds. This really sucks, I had plans for New Years and now I'm stuck at my uncle's near Waukesha...130 miles from home with my car not starting.