Thread: What did you do to your Car today?

well not crack it, but smash the electrode.

Originally Posted by acidcrashdburnd

I hope not. Only 8k on this new engine.. I'll murder her because I'll be expected to fix it.

Sent from my Galaxy Nexus using Tapatalk 2

I think you should check for a vacuum leak in injector 6. Bad injector Orings could be your culprit.

Originally Posted by SDGTP99

I think you should check for a vacuum leak in injector 6. Bad injector Orings could be your culprit.

It is consistently random, it will not miss till 5k sometimes and other times it will miss around 3k rpm. sometimes it wont miss at all. I will make a thread on her tomorrow.

Originally Posted by danielle15

I plan on it. There is a touchless that has a decent underbody until rear wheels go over and it stops. So ill start there and hope that gets it all.

The touchless by me that I use during winter has an undercarriage wash that doesn't stop until you hit a sensor in front of the car and there's enough room to get the whole car in. So I go over it and back up and go over a few more times

Originally Posted by acidcrashdburnd

It is consistently random, it will not miss till 5k sometimes and other times it will miss around 3k rpm. sometimes it wont miss at all. I will make a thread on her tomorrow.

Pull the #6 wire off the O2 sensor connector/body of sensor.

Originally Posted by BillBoost37

Pull the #6 wire off the O2 sensor connector/body of sensor.

Haha its not touching. I am gonna pull the icm off and clean the surface.. clean grounds.. yaaay.

Sent from my Galaxy Nexus using Tapatalk 2

Why..the ground wire in the connector isn't good enough? 92-95 you had to clean the connections.. 96+ they added the wire that is held under the coolant elbow by a nut.

Put my other coils on and the car is back to normal. Everyone would also like to know my spoiler is back on...for now.

Originally Posted by BillBoost37

Why..the ground wire in the connector isn't good enough? 92-95 you had to clean the connections.. 96+ they added the wire that is held under the coolant elbow by a nut.

It may not be. The whole engine bay is crusty. I'll clean it won't take longer than 20 minutes.

Sent from my Galaxy Nexus using Tapatalk 2

One nut and a quick cleaning. Better not take more than 20 min..lol

Good News! I dont have to drive my moms car anymore. the PCM is in ready mode and no SES light... yyyaayyy

lets just forget the missfire lol

Originally Posted by Mad Monkey

lets just forget the missfire lol

PRETTY MUCH.

**** that thing.

Not really though I am going to work on it with my uncle tonight. He is bringing a compression checker, injector O rings, and known good plug/coil/wire. I think it is an injector or the ICM. I put all good plug/coil/wire on cyl 6 last night same thing. The parts came off of my GP pre top swap, and that car ran perfect.

Last night discovered a tire low on air. Filled it up in the morning, held all day. Took it to the shop. They found a nail in the tire wall. Glad I bought road hazard. New tire replaced one I bought three weeks ago.

I made it a shopping list
Gloss black paint
Clear coat
VHT nightshade
1000 or higher sandpaper
Some thinner or acetone

I will be doing two things here. Can you guess what?

wheels and tails.. I WIN!

I bought a ovekill pcm for my gp to day

Roof rails and tails lol

Low coolant light came on today. Put some water in and doing a coolant flush tomorrow. Thinking it might be leaking really slowly from around the tb since I didn't replace the gasket after I cleaned it? Also doing an oil change tomorrow if there's enough time.