|
|
3 Weeks Ago
Hi all
I posted about the mess with the codes on my 2000 Pontiac Grand Prix GTP before here in the forum.
Last code was P1133
But now I have:
P1133
P1361
P1362
And now I have a check engine light.
It goes on and on theres no end or anything I think all on this car is a mess.
These codes are for the ignition module and the crankshaft position sensor I think.
What can I do against this?
Last edited by kappa67; 3 Weeks Ago at 10:25 AM.
2 Weeks Ago
Yes and no it was there after the check engine light came on.
2 Weeks Ago
FYI, my post is a link to some info if you didn't click on it.
2 Weeks Ago
Yes saw it...thanks
Thats why the indicator light is off now:
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
1 Week Ago
And now next thing:
Sometimes car has misfires with ignition and after this the Computer goes wild.
All is blinking
I think this is due the codes I have the p1361 and p1362 codes
I don't know but the car is only scrap and I can't drive it anymore
Indicator light is on again
If I have a short in the wires somewhere then good night can't find out by myself.
So many parts are new: The O2 sensor by the engine, the igition modules the ICM don't know what to do now
Last edited by kappa67; 1 Week Ago at 12:07 PM.
1 Week Ago
I would check the harness for the cam and crank position sensors. If the harness gets messed up it can cause those codes to pop up.
1 Week Ago
Where is the harness for the cam?
For the crankshaft sensor its ok
1 Week Ago
It comes off of the harness for the ICM if I recall. It runs down under the coils/ICM and into the front of the engine. Cam is up top and then the crank sensor lives behind the crank pulley/balancer. It can get rubbed by the drive belt if not secured properly, seen that one before.
1 Week Ago
Ok thanks tomorrow I will take a look
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
