Thread: ZZP Pulleys, ZZP Pulley Puller, LS7 lifters, Intense PCM, etc.

I have a full ZZP Stage 2 Intercooler system for Gen 3 superchargers. I'd like to sell the whole kit together as one. It will come with everything listed on the ZZP website, minus the intercooler gaskets as I doubt they will be reusable. All hoses, fittings, wiring, bosch intercooler pump, dual pass heat exchanger etc. It will also come with the ZZP modified fuel rails, ZZP ported and machined lower intake manifold, a felpro LIM gasket, basically everything to get it set up and running on your car. I ran it for about 5000 miles with 0 KR using a 3.2 pulley on an otherwise stock engine. SOLD

Also for sale:

ZZP Pulley Puller, with all needed hardware - $80

3.5 Pulley - $40

3.2 Pulley - $40

Intense racing 1998 GTP PCM - $80

Stock 1998 GTP PCM - $50

Intense fenderwell intake silicon coupler, with IAT bung - $35

9" Long K&N filter - $25

12 LS7 Lifters, never used - $65

All other parts on the engine are for sale also, just not listed. Supercharger is still good but could use a new coupler, throttle body is good, basically anything that is not the bottom end. Shoot me an offer on anything you might need or anything listed above.

Located in Palm Coast, FL. Feel free to make an offer on anything. All prices are shipped price.

Upgraded rockers?

Can you post some pitcure so we can get an idea of condition? I havent put 5k miles my car is 3 years. even if everything is still in the car thanks in advance

https://imgur.com/a/fAmjB Here is some pictures of the intercooler, it's still in the car so it's pretty tough to get an idea. Rest of my engine bay is pretty crusty but the IC set up is all clean. Will get it taken off this weekend and get better pictures of everything, just haven't had the time to get it all off. They will look a lot better off the car, everything was only ran for about 9 months and 5000 miles.

Pushrod67 Email has now been sent.

And no Pursell, they were stock rockers.

Originally Posted by BigNelson76

details on the pcm?

I sent intense the parts list on my vehicle and this is what they sent me (stage 2 intercooler, 2.5" downpipe with u bend, and cat delete, 2.5" cat back exhaust, 3.5 pulley and 3.5" hot air intake with K&N intake, skip shift setup and 180 degree theromostat in it.) Not 100% sure what they did, but it ran great on my set up with no misfires and 0 KR in all situations. The stock PCM is off a 1998 GTP, nothing done to it.

PM'd for pulley puller.

Do you still have the 3.5" pulley, if so is it modular and a pic would help, pm me.

Interested in the puller. Is it complete? PM me

email sent. Interested in the modular pulleys