Hey guys doing some work for a friend. I changed pads,rotors,calipers on back. Wheel got hot but is not getting hot now.. but makes grinding noise wondered what it could be?
|
|
09-09-2019
Hey guys doing some work for a friend. I changed pads,rotors,calipers on back. Wheel got hot but is not getting hot now.. but makes grinding noise wondered what it could be?
09-09-2019
wheel bearings good?
09-10-2019
They seem like it. No play and turn by hand smoothly
09-10-2019
most people will recommend checking to see if the dust shield is scraping on the back easy fix and worth checking but when I was in a similar position as you it turned out to be the new brake hardware was scraping against the outer cylindrical face of the rotor. the shim has to bend it out a bit if so or try different shims
09-10-2019
id check the dust shield. jack the back tire up, hand spin the tire. listen for the sound.
if you did rotors too a lot of the time the ebrake drum is not the same as the old one and needs to be re adjusted, could be dragging and needs to be backed off. sadly you need to take the rotor off to adjust the e brake.
09-10-2019
crap 05, scratch the e brake drum jazz lol but do make sure the cable is not holding the lever on the caliper.
09-10-2019
E brake isn't hooked up... I'm starting to think the brake lines are collapsing... you can't flipping hear anything cause the exhaust... but she swears she hears something then it goes away.. front brakes are starting to cut into the rotors I think that's the noise plus back passenger is still sticking getting hot even though all new. So think rubber brake lines are shot after 308k.. lol
09-10-2019
its either the hose or the caliper is sticking. most bad hose cases seem to be the fronts tho, the rear is a kinda short hose.
09-10-2019
New caliper so I'm thinking hose
09-12-2019
Think that's where I would start. The dust shield would be my second guess. They are only a couple mm away from the rotor and just a little rust build up on the edge of the shield will make them rub on the rotors.Originally Posted by Natcox012
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
