Activity Stream

At 131K that engine is just barely getting broken in. Are you sure it's a lifter tick and not an exhaust leak? Even at that, the lifters in these...

Yes saw it...thanks Thats why the indicator light is off now: The control module turns OFF the malfunction indicator lamp (MIL) after 3...

You check the fuses under the hood and on the inside panel? Just asking in case something easy was overlooked. If this car came with any kind of...

Lando was able to close the gap in the last few races but after yesterday's race win by Max, the gap is now once again 62 points with only 3 races to...

Well I do have two keys but both do same thing, (sometimes takes 2 or 3 tries sometimes 5 or 6 and then sometimes 1st try) and I have changed the...

FYI, my post is a link to some info if you didn't click on it.

Sounds like an issue with the transponder in the ignition switch or the switch itself. Do you have another key you can try?

Yes and no it was there after the check engine light came on.

p1361 B and p1362 B codes came up on the way home tonight?

Found one failure...it has a leak in the exhaust. ​Will fix that and then take a look

I found this which should be helpful. DTC P1133 or P1153

That is the ones I got

And to fill the other hole on the A-pillar pod here is the Voltmeter gauge I installed--> Just a moment...

Below is the gauge I went with. You could choose any 2 1/16" gauge for the pod. Don't get a mechanical gauge. You don't need to have an oil line...

Not sure which ones you got from Amazon, but if they are the Dorman ones they should be fine. I've had my alum. ones in for over 200K with no...

4 ok doesnt seem tooo bad lol what is the unit that replaces the actual sensor itself or is it like a kit with that gauge also do you...

I changed the upstream O2 sensor but got the code P1133 anyway. ​What could this be?? All the other codes are gone.

Not really. Just a single wire with a ring terminal crimped on at the sending unit then run up to the gauge. Then you tap into a power source for...

is it hard to wire into the system?

Now I will change the O2 sensor before the Kat. And I have no engine light.... Maybe this helps ...

That is a tricky code. If we ignore that and just focus on fuel efficiency, your MAF sensor may stand a cleaning.