Register
Help
What's New?
Activity Stream
New Posts
New Group Messages
New Events
New Articles
New Blog Entries
Mark Forums Read
Articles
Forum
Blogs
Garage
Advanced Search
Home
Activity Stream
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 24 Hours
Last 24 Hours
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Articles
Articles
Blog
Blogs
Local Chapters
Local Chapters
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
1 Hour Ago
kappa67
replied to a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
I have no codes nothing
see more
7 replies | 118 view(s)
17 Hours Ago
FordMan77
replied to a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
I have had bad coils take out an ICM a few times. Grab an OEM one from the junkyard (along with the coils, because why not have spares?) and throw...
see more
7 replies | 118 view(s)
1 Day Ago
BrandonHall10
replied to a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
What are the codes?
see more
7 replies | 118 view(s)
1 Day Ago
kappa67
replied to a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
News on the car....it shot off again and runs very unclean........ So there are more than the coils. I don't know maybe the plate under the coils?...
see more
7 replies | 118 view(s)
1 Day Ago
jeepers
replied to a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
The aftermarket ones, both MSD and ZZP, only look nice. There are no performance gains to be had from them.
see more
7 replies | 118 view(s)
1 Day Ago
kappa67
replied to a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
Yes that I did with them...red coils looks good. And you have not better electricity and so with the aftermarket ones? More power on the car?
see more
7 replies | 118 view(s)
1 Day Ago
FordMan77
replied to a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
The OEM ones are known to be the best to use. Stick with those and don't look back. If you want you can paint them to make them look non-stock if...
see more
7 replies | 118 view(s)
2 Days Ago
kappa67
started a thread
Misfires and more
in
3.8L V6 Supercharged (L67)(L32)
Hi all Had yesterday I had some misfires on my car (2000 Pontiac Grand Prix GTP) Sometimes he shot off completely. Whats that? So I changed the...
see more
7 replies | 118 view(s)
1 Week Ago
jan
replied to a thread
A/C air getting "stuck" behind the dash
in
General Tech Discussion
The condenser is clear of dust and road debris, but has never been replaced, so it's old and a lot of the fins are bent. I did replace the radiator...
see more
4 replies | 792 view(s)
1 Week Ago
FordMan77
replied to a thread
A/C air getting "stuck" behind the dash
in
General Tech Discussion
If the pressures are still good, how clean is the condenser? Getting good air flow through it (i.e.- not filled with road junk)?
see more
4 replies | 792 view(s)
1 Week Ago
jan
replied to a thread
A/C air getting "stuck" behind the dash
in
General Tech Discussion
Didn't see this until now, my apologies. Thank you for the reply. I haven't checked recently, but the compressor died about two years ago and I...
see more
4 replies | 792 view(s)
1 Week Ago
FordMan77
replied to a thread
Trouble with my 2.8 L
in
Engine
Let's start with the basics. When was the last time the plugs are spark plug wires were replaced? The crank sensor should be on the backside of...
see more
1 replies | 594 view(s)
1 Week Ago
FordMan77
replied to a thread
Hello from Germany
in
Introductions/Noob Questions
Welcome to the site. Though this site is more geared towards the 97+ grand prix there is likely some info here to help you get it running right...
see more
1 replies | 810 view(s)
1 Week Ago
MoparMadcat
started a thread
Trouble with my 2.8 L
in
Engine
Hello, I got some unsolved mystery trouble with my 2.8 Liter Grand Prix. The engine shut down after it get in operation temperature. The car...
see more
1 replies | 594 view(s)
1 Week Ago
MoparMadcat
started a thread
Hello from Germany
in
Introductions/Noob Questions
Hello from Germany
I'm 29 years old and been into American cars (special Mopar ) since i was a kid. Though the years i owned many different...
see more
1 replies | 810 view(s)
2 Weeks Ago
SgtMarshal
replied to a thread
1982 Chevy S-10 with 6.0 LQ4 swapped S10 with M90 gen 5 supercharger
in
Members Rides
https://youtu.be/pia3breOrAo?si=m77xIYqBrZlr0R8e https://youtu.be/xMk7VCfQjtc?si=uWA03my44LxUxqp_
see more
5 replies | 1449 view(s)
2 Weeks Ago
Texas3
replied to a thread
Why Does My Gas Gauge Not Work?
in
General Tech Discussion
had the same issue with my '03 lived with it doing fuel calculations on paper for years. The fuel pump finally went, and was replaced, fixed the...
see more
12 replies | 4425 view(s)
2 Weeks Ago
FordMan77
replied to a thread
Windows won't work
in
5.3L V8 (LS4)
Might be a BCM issue (body control module)
see more
1 replies | 530 view(s)
2 Weeks Ago
Sammie8809
started a thread
Windows won't work
in
5.3L V8 (LS4)
My husband left 06 GXP driver window down in the snow last winter and now I cannot get my trunk to open with the switch, none of my windows will go...
see more
1 replies | 530 view(s)
2 Weeks Ago
alok
started a thread
strips of vinyl along bottoms of windows, inside on side door panels
in
General Tech Discussion
Any idea what the thin aluminum foil is for under these strips? My guess is "heat" from the sun through the windows, the thin foil maybe prevents...
see more
0 replies | 337 view(s)
2 Weeks Ago
LivinCorrupt
started a thread
Looking for projector headlight housing
in
1998
Looking for projector headlight housing with H5 support. I found some that are h1/h3/hb3 I haven't found any that are H5 I Wana get color changing...
see more
0 replies | 1022 view(s)
2 Weeks Ago
FordMan77
replied to a thread
time for struts again
in
Brakes/Suspension/Chassis
I always run KYB struts. You can get them on RockAuto for a good price and don't forget the strut mounts too. Then just have a shop assemble them...
see more
1 replies | 771 view(s)
2 Weeks Ago
tomsteve
started a thread
time for struts again
in
Brakes/Suspension/Chassis
'08 GP base getting a bit saggy and soft. besides Monroe quick struts, what suggestions do ya'll have for replacements? im just an average every...
see more
1 replies | 771 view(s)
2 Weeks Ago
SgtMarshal
replied to a thread
1982 Chevy S-10 with 6.0 LQ4 swapped S10 with M90 gen 5 supercharger
in
Members Rides
the supercharger belt is tracking straight on all the pullies now and oh boy is it fun to drive. the front brakes aren't strong enough to hold the...
see more
5 replies | 1449 view(s)
2 Weeks Ago
MKnight21
replied to a thread
Rusting rear strut towers
in
Brakes/Suspension/Chassis
I know this is an old post but I'm in the same situation & wanted to know how everything worked out for you? Did the repair last?
see more
23 replies | 16188 view(s)
2 Weeks Ago
MKnight21
started a thread
Strut Tower Replacement (2000 GTP Coupe)
in
Introductions/Noob Questions
I noticed that my rear driver strut tower is rusted & needs to be replaced. I looked up multiple sites such as Doorman, but I see towers for almost...
see more
0 replies | 528 view(s)
3 Weeks Ago
jeepers
replied to a thread
P1629 and P1673
in
General Tech Discussion
It sounds like an issue with the after-market remote start. These need to override anti-theft systems since the security chip in the key won't be...
see more
6 replies | 3182 view(s)
3 Weeks Ago
BrandonHall10
replied to a thread
P1629 and P1673
in
General Tech Discussion
When you cycle the key, does the "Engine Hot" or "Overheat" (or whatever the warning light for over temp says) light up during the bulb check?
see more
6 replies | 3182 view(s)
3 Weeks Ago
fomas
replied to a thread
P1629 and P1673
in
General Tech Discussion
So how do you fix the p1673 code need help I have this code 99 grand prix gt
see more
6 replies | 3182 view(s)
3 Weeks Ago
Tmcttk
replied to a thread
Adjust cooling fan turn on temps
in
PCM Tuning
Sorry for not answering earlier, I wasn't sure the forum was working and had log-in issues. I'm going to look into PCM Hammer and I have an OBD 2...
see more
8 replies | 5893 view(s)
More Activity
No More Results
No Recent Activity